... metazoa, their density per surfacearea was high in the gravel-filled channel, and oxygen uptake rate downstream also became higher Based on the above, it suggests that surfacearea and porosity of ... Water level (m3・d-1) (m・s-1) (m) brick 130 0.125 0.118 gravel 101 0.127 0.122 Cross sectional areaSurfacearea (m2) (m2・m-flow direction-1) 0.0252 0.55 0.0257 Analytic method of water quality Collecting ... proceeded in both channels Biotas of both channels are listed in Table Although total number of bacteria per surfacearea virtually does not change at the inflow section, while it decreased downstream...
... GAC TAC TCC CTG-3¢, the antisense primer 5¢-AAG AAT TCT AGA TTA ATG GTG ATG ATG GTG ATG ATG GTG TGG GGT CAG CGG TGC AGC AGG GGG GGT-3¢ (XbaI sites underlined; His-tag in italic) and pVL1393–HSL ... study, we provide evidence that HSL gains accessible hydrophobic surfacearea upon PKA phosphorylation This gain in hydrophobic surfacearea presumably accounts for the increase in in vitro activity ... HSL for all four concentrations of SYPRO Orange, thus strengthening the argument that HSL gains solvent-exposed hydrophobic surfacearea upon phosphorylation Electron microscopy of phospholipid...
... fat and add to the liver glut Body Mass Index Calculator Body mass index is a measure of how much body fat we have, based on our height and weight To find out your body mass index, or BMI: Figure ... stomach, is your largest internal organ, weighing about percent of your body s total weight Almost all metabolic activities and body functions are dependent on the liver in some way, and that’s why ... The Inside Out Diet Weeks to Natural Weight Loss, TotalBody Health, and Radiance Cathy Wong, N.D C.N.S with Recipes by Sabra Ricci John Wiley & Sons,...
... specific surface areas and porosity The specific surfacearea and porosity can be up to 112 m2 gÀ1 and 81%, respectively The field emission properties of the obtained high specific surfacearea porous ... fabricated at 1500 1C for h with Ar pressure of 0.15 MPa using our proposed process Property Value Specific surfacearea (m2 gÀ1) Median pore diameter (volume) (mm) Median pore diameter (area) (nm) ... of the external surface and fracture surface of the resulted porous SiC ceramics coated with reticulated SiC nanowires, respectively Fig 2(a) clearly reveals that the external surface of the fabricated...
... (SEM, JEOL JSM- 6500 FE), transmission electron microscopy (TEM, JEOL JEM-200CX), and selectedarea electron diffraction (SAED) The Brunauer–Emmett– Teller (BET) specific surfacearea was determined ... BET surfacearea and pore volume of the as-synthesized nanosheet TiO2 are about 642 m2/g and 0.774 cm3/g, respectively The as-synthesized nanosheet TiO2 (prepared by this method) showed higher surface ... nanosheets The flower-like structure had a diameter about 500 nm to μm (Fig 3(a)) The nanosheet structure was slightly curved and approximately 50 100 nm in width and several nanometers in thickness...
... R Y Totalbody Lift FINAL 7/18/06 6:53 AM Page 15 Chapter Creation of TotalBody Lift™ Surgery Totalbody Lift FINAL 7/18/06 6:53 AM Page 16 TotalBody Lift represents a paradigm shift in body- contouring ... Innovation and Principles Chapter Lower Body Reshaping 77 Totalbody Lift FINAL 7/18/06 6:53 AM Page 10 Chapter 105 Upper Body Reshaping Chapter 125 TotalBody Lift™ Surgery for Men Only Chapter ... demanded a unifying approach I created TotalBody Lift surgery to meet this challenge of extreme body contouring TotalBody Lift surgery transforms the entire body in one to two stages Advances in...
... And that means a harder, leaner body In this special 4-week total- body fat-loss program, you’ll work your muscles harder than ever before by focusing on total- body movements So you’ll twist when ... Build strength and muscle size with equal effort on both sides of your body Working the front and neglecting the back is a recipe for injury Some suggestions: Ǡ BEGINNER Do a total- body workout ... Build strength and muscle size with equal effort on both sides of your body Working the front and neglecting the back is a recipe for injury Some suggestions: Ǡ BEGINNER Do a total- body workout...
... cm), Ht is body height (cm), BW is body weight (kg), D is body density (1.05 kg/l) and KB ¼ 4.3 is a shape factor.12 ICW ¼ ECW* ÂÀÀ À rTBW *R0 Þ= rECW *Rinf ÁÁð2=3Þ À1 Ã (2) where totalbody resistivity ... TBSMMDxA as dependent variable First, a SF-BIA equation: TBSMM50 kHz (gender, height in cm (Ht), BW, R(resistance )50 kHz and Xc(reactance )50 kHz included) Second, an equation using BIS model predictors: ... Cm was found not to be significant BIA- and BIS-equations: TBSMM50 kHz ¼ À24.021 þ (0.33 Â Ht) þ (À0.031 Â R50 kHz) þ (0.083 Â Xc50 kHz) þ (À1.58 Â gender) þ (0.046 Â BW) TBSMMBW ¼ À23.953 þ (0.333...
... Powder surfacearea and porosity.—2nd ed.— (Powder technology series) Powders—Surfaces Surfaces—Areas and volumes I Title II Shields, Joan E III Lowell, S Introduction to powder surfacearea IV ... maximum area- to-volume ratio All particulate matter Powder SurfaceArea and Porosity possesses geometry and therefore surface areas between these two extremes The dependence of surfacearea on ... imperfections will always create real surfacearea greater than the corresponding geometric area 1.2 Factors affecting surfacearea When a cube, real or imaginary, of m edge-length is subdivided into smaller...
... [6,8-12] Lp-Dual geominimal surfacearea In this section, we research the Lp-dual geominimal surfacearea First, we give a property of the Lp-dual geominimal surfacearea under the general linear ... absolutely continuous with respect to surfacearea measure S(K, ·) n A convex body K ∈ Ko is said to have an Lp-curvature function [3]fp(K, ·): Sn-1 ® ℝ, if its Lp -surface area measure Sp(K, ·) is absolutely ... mixed volume, we give the notion of n Lp-dual geominimal surfacearea as follows: For K ∈ Sc , and p ≥ 1, the Lp-dual geomi˜ nimal surface area, G−p (K), of K is defined by − p p n ˜ ˜ ωn n G−p...
... orifice (ERO) area obtained by the proximal isovelocity surfacearea (PISA) method and by quantitative Doppler echocardiography (A) The difference between the proximal isovelocity surfacearea (PISA) ... isovelocity surfacearea The theoretic basis for calculating the effective regurgitant orifice (ERO) area has been described previously The calculation was based on following formulas [9,27,28] Flow = Area ... obtained by the proximal isovelocity surfacearea (PISA) method and by quantitative Doppler echocardiography (A) The difference between the proximal isovelocity surfacearea (PISA) and the Doppler values...
... 5'–CTTACACTATTCCTCATCACCCAACTAAAAA–3'), reverse primer (ß-actin: 5'–TGGCATTGCCGACAGGAT–3'; HVR2: 5'–GTTTAAGTGCTGTGGCCAGAAG–3'; CD: 5'–GGAGTAGAAACCTGTGAGGAAAGG–3') and TaqMan MGB hybridization probes (ß-actin: 5'–AAAGACACCCACCTTGAT–3'; ... common deletion (CD), are key indicators of irradiation-induced damage The relationship between totalbody irradiation (TBI) treatment and mtDNA alterations in vivo, however, has not been postulated ... toxicity Keywords: mtDNA; 4977-bp Common Real-time-PCR; Acute lymphoblastic leukemia -2- deletion; Totalbody irradiation; Background Breakage of cellular DNA following radiation is a dose dependent...
... From the isosurface based volume rendering of the ET reconstructions, the totalsurfacearea and volume of their composing gold particles could be measured For example, the totalsurfacearea and ... surface was smoothed using a × × averaging of voxels (downsampling) Using the ‘Create Surface function of Amira, a surface was derived from the isosurface, which allowed measurement of the surface ... on their electron density and size The surfacearea and volume of individual spherical particles were approximated by the formulas to calculate the surfacearea (4πr ) and the volume (4/3πr ) of...
... cluster analysis of low attenuation areas for comparison with histological measurement of surfacearea per unit lung volume Methods: The histological surfacearea per unit lung volume was estimated ... histological surfacearea per unit lung volume and CT measures Results: The median CT lung density, low attenuation cluster analysis, and the combination of both were important predictors of surfacearea ... being 100 × 100 μm yielding a total volume of the “lung” = 16,000 μm3 with a surfacearea of 6,400 μm2 and a SA/V of 0.4 If we assign a mass of 10 units to each 100 μm length of “alveolar wall” this...
... number areasurfacearea upon exposure surface and Intracellular particle number and surfacearea upon exposure to the same particle surfacearea Cells were exposed to the same totalsurfacearea ... the surface density (SV) of the APM was calculated from the number of intersections (I) and the total length of the test line (LT) hitting the reference space [39] The total APM surfacearea ... particles and the surfacearea of × 108 μm particles are approximately equal to the mass and surfacearea of 4.5 × 1011 0.05 μm particles, respectively Increases in the surfacearea of the APM...
... exposed surfacearea due to the existence of remaining polymer on the Pt surface XRD would be insensitive to this circumstance, while chemisorption would directly probe this loss of surfacearea ... was based on the total, rather the irreversible (strong) uptakes Boudart20 has suggested that the total rather than the irreversible uptake is a better measurement of Pt surfacearea when Pt is ... Pt/SBA-15 1.01% Pt/SBA-15 CO particle size, d (nm) TEM particle sizeb H2 totaltotal irrev O2 irrev H2-O2 total dispersion, D, H2-O2, total 1.7 2.6 2.9 3.6 3.6 7.1 12.3 133.1 7.4 3.9 6.8 3.7 4.0 2.1...
... (1996) Characterization, surfacearea and porosity analyses of the solids obtained by acid leaching of a saponite Langmuir, 12, 566–572 Walling, C (1 950) The acid strength of surface Journal of American ... Bhat, 1995; Noyan, O Sarıkaya, 2006; Walling, 1 950) The molar number of acid sites in g solid is defined as surface acidity (nm) The acid strength of a surface can be characterized by the equilibrium ... the surface properties of bleaching earths has yet appeared The aim of this study is to examine of the bleaching power of some H2SO4-treated bentonite samples by making use of surface area, surface...
... zirconia had a surfacearea of 130 m2/g after calcining at 350 ºC Further heating at 450 ºC led to a decrease in surfacearea to 40 m2/g Another route to produce high surfacearea zirconia is ... digestion in acidic medium had lower surface areas of
... 2:30pm where part of the area in the facade surface showed a red dark which indicated high temperature (Figure 9) The red areas in the thermograph occurred on external surfaces of the building ... effectiveness of the outdoor survey due to surface temperature shear effects Similarly, rain may also lead to surface cooling, thus masking thermal effects from below the surface Information of thermal behavior ... greenhouse effect and evaporation surfaces [5] The maximum UHI intensity usually occurs to h after sunset in the urban area [6] Some of the radiation reflected from these surfaces leaves the urban environment...