... cáo về sửdụng Incoterms.
6. CÁC DOANH NGHIỆP VI T NAM NÊN SỬDỤNG INCOTERM NHƯTHẾ
NÀO?
Phân tích về nội dung cũng như đúc kết ra những lưu ý khi sửdụng Incoterms để
từ đó vận dụng so sánh ... Yêu cầu của vi c giải thích các thuật ngữ quan trọng
Những từ vi t tắt như FCA, FOB và CIF có thể được xem như là những "từ ngữ
quan trọng", những từ này, khi được sử dụng, đã xác ... mại quốc tế
10. VietShip – Diễn đàn Giao nhận & Vận tải Vi t Nam http://www.vietship.vn
11. Export Vietnam Forum
12. L.S VÕ NHẬT THĂNG – “Bài học từ một hợp đồng Nhập khẩu”
13. Viet Nam Marine...
... - 10:06 AM
Lò nấu visóng
Lò Visóng (Microwave oven - sóng cực ngắn) hiện nay đã ngự trị trong bếp của nhiều gia
đình cũng như tại công sở, trường học…. Dân giầu có thì sắm một lò gắn vào tường ... liệu.
Nhưng cũng như mọi sáng chế của khoa học, lò cũng có những rủi
ro, bất lợi.
Xin cùng tìm hiểu thêm về bếp nấu hiện đại này.
KHCN Số 4 giới thiệu cùng bạn đọc về lịch sử ra đời lòvi sóng, ... nó, cũng như cách dùnglò sao cho hiệu
quả và đúng hướng dẫn.
Lịch sửlòvisóng
Nhiều phát minh khoa học là kết quả của nhận xét tình cờ. Kháng
sinh Penicillin được tìm ra khi nhà vi trùng...
...
chúng trong suy nghĩ của khách hàng cũng như nhà phân phối. Và họ tin rằng vi c xây dựng chiến lược
thương hiệu sẽ hỗ trợ điều đó.
Nhưng thực tế lại không như vậy!
Theo cách nghĩ trên, công ty ... thay vìsửdụng phương pháp nội soi để xác định giá trị thương hiệu, chắc chắn
họ sẽ trả lời một cách máy móc “Bởi mọi kiến thức thương hiệu đều suy ra từ người tiêu dùng” hoặc đại khái
như: “Do ... quản lí mới trong dài hạn. Vì thế, điều chúng ta cần thấy tốt hơn hết mọi thứ nên gác lại
cho đến khi công ty có thể đưa ra được một chiến lược quản lí dài hạn thay thế.
Không phải chỉ mỗi công...
... chống hữu hiệu tình trạng táo bón. Điều
cần chú ý là, những người bị đi lỏng mạn tính do vi m đại tràng hoặc vi m dạ dày mạn tính không nên ăn mộc nhĩ
đen.
ThS. Hoàng Khánh Toàn
...
... wavelengths between 1 m
(10
–6
m) and 1 mm. Beyond the infrared spectrum is the visible optical spectrum,
the ultraviolet spectrum, and x-rays. Below the microwave frequency spectrum is
the radio ... tuning. Here the costs for the design and tuning can be reduced greatly by using
CAD, which can provide more accurate design with less design iterations, leading to
first-pass or tuneless filters. ... developments in this area are cer-
tainly being stimulated by increasing computer power. Another driving force for the
developments is the requirement of CAD for low-cost and high-volume production.
In...
... ports of the network NЈЈ ; and all the S submatrices con-
tain the corresponding S parameters. Obviously, p + c = M
1
and q + c = M
2
. It is
[aЉ]
q
[aЉ]
c
[SЉ]
qc
[SЉ]
cc
[SЉ]
qq
[SЉ]
cq
[bЉ]
q
[bЉ]
c
[aЈ]
p
[aЈ]
c
[SЈ]
pc
[SЈ]
cc
[SЈ]
pp
[SЈ]
cp
[bЈ]
p
[bЈ]
c
b
i
ᎏ
a
j
a
1
a
2
Ӈ
a
M
S
1M
S
2M
Ӈ
S
MM
... at port 2 of the network NЈ and port 1 of the network N Љ
when SЈ
mn
and SЉ
mn
are evaluated individually.
2.8 NETWORK PARAMETER CONVERSIONS
From the above discussions it can be seen that for ... composite
network is given simply by the sum of the short-circuit admittance matrices of the
individual networks.
Analogously, the networks of Figure 2.3(b) are connected in series at both their
input...
... the same 3 pole
Butterworth lowpass prototype as that used previously in Section 3.3.1, Figure
3.15(b) illustrates a bandpass having a passband from 1 to 2 GHz obtained using the
element transformation.
3.3.4 ... = 1 to n (3.24)
g
n+1
= 1.0
For convenience, Table 3.1 gives element values for such filters having n = 1 to 9.
As can be seen, the two-port Butterworth filters considered here are always sym-
metrical ... be chosen.
3.2.2 Chebyshev Lowpass Prototype Filters
For Chebyshev lowpass prototype filters having a transfer function given in (3.9)
with a passband ripple L
Ar
dB and the cutoff frequency...
... previous expressions for
re
are
obtained based on the quasi-TEM or quasistatic approximation, and therefore are
rigorous only with DC. At low microwave frequencies, these expressions provide ... expressions also provide accuracy better than one percent. If more accurate
values are needed, an iterative or optimization process based on the more accurate
analysis models described previously can ... 4.10(h).
These microstrip patch resonators can be analyzed as waveguide cavities with mag-
netic walls on the sides. The fields within the cavities can be expanded by the
TM
Z
nm0
modes, where z is perpendicular...
... Semilumped Lowpass Filters Having Finite-Frequency
Attenuation Poles
The previous two types of microstrip lowpass filter realize the lowpass prototype
filters having their frequencies of infinite ... (b)
can only be electrically equivalent to the combline filter in the vicinity of the mid-
band frequency, and its stopband behavior is different from that of the combline fil-
ter.
Similar to the ... inductances L
1
, L
3
, and L
5
block transmission by
having infinite series reactance, whereas the capacitance C
6
shorts out transmission
by having infinite shunt susceptance.
A microstrip filter...
... design this type of filter, let us consider the design of an op-
timum distributed highpass filter having a cutoff frequency f
c
= 1.5 GHz and a 0.1
dB ripple passband up to 6.5 GHz. Referring to Figure ... = 1 to n
where b
i
are the susceptance slope parameters of series parallel resonators.
It is obvious that for a chosen lowpass prototype, with known element values, the
desired reactance/susceptance ... relative dielectric constant of 10.8 and a thickness of 1.27
mm. The bandstop filter is designed to provide an RF rejection better than 40 dB
over an operating frequency band from 3.5 GHz to 5.5 GHz....