... thấy, NAT sẽ thay thế địa chỉ đích bằng địa chỉ outside local từ bảng NAT.
Nếu NAT không tìm thấy một hàng nào, nó sẽ tạo ra một hàng mới trong bảng NAT và cũng thực
hiện như ở bước 2.
thật.
NAT ... 1.
II: Kỹ thuật NAT động (dynamic NAT) .
Với NAT, khi số IP nguồn không bằng số IP đích. Số host chia sẻ nói chung bị giới hạn bởi số IP
đích có sẵn. NAT động phức tạp hơn NAT tĩnh, vì thế chúng ... tất cả các DNS data đã được relay bởi NAT
Phần I:
Giới thiệu tổng quan về NAT (Network Address Translation)
I : NAT (Network Address Translation) là gì ?
NAT giống như một router, nó chuyển tiếp...
... Kind Attributes 170
Chapter 7 Configurations 173
Default Configurations 174
Component Configurations 176
Lower-Level Configurations 179
Entity-Architecture Pair Configuration 180
Port Maps 181
Mapping ... level in the design.
Let’s look at a configuration statement using the netlist architecture of
the
rsff
entity. The following is an example configuration:
CONFIGURATION muxcon1 OF mux IS
FOR ... 183
Generics in Configurations 185
Generic Value Specification in Architecture 188
Generic Specifications in Configurations 190
Board-Socket-Chip Analogy 195
Block Configurations 199
Architecture Configurations...
... đúng
A)Từ khóa throw và throws phải đc sử dụng bởi phương thức mà có thể
truyền các lỗi
Đề Thi Java By Example (27-6-2008)
1.Cho đoạn mã chương trình sau:
For( int y=2 ; y= ){
System.out.print(x+ ““+...
... its main means of communication?
34.Zoos are sometimes seen as necessary but not poor alternatives to a natural environment.
Discuss some of the arguments for and/or against keeping animals in ...
technology. Give your views in not less than 250 words.
8. Should poor countries continue to receive International Aids? Give your views in not less
than 250 words.
9.Some parents grow their children in...
... Check your NAT configuration by using extended ping command with the source address
is Lo 0 and the destination is 10.2.0.251
5. Erase static NAT configuration. Configure dynamic NAT on R-X ... outside
R-X(config)#int loopback 0
R-X(config-if)#ip nat inside
R-X(config)#int e0
R-X(config-if)#ip nat outside
3. Configure static NAT on R-X so that the private IP address of Lo 0 interface ...
8. Check your NAT configuration by using extended ping command with the source address
is Lo 0 and the destination is 10.2.0.251
9. Using show and debug command to verify your NAT configuration
...