metal metal cyanide complex solids

Design and synthesis of novel metal complex protein conjugation agents for applications in bio imaging

Ngày tải lên : 16/10/2015, 11:57

... form complexes with a large number of transition and lanthanide metal ions with high thermodynamic stability and kinetic Chapter Introduction inertness[9] DOTA complexes, depending on the metal ... one disulfide bond is reduced[61] 1.6 Design of biocompatible metal- complex protein conjugates In order to design biocompatible metal- complex protein conjugates which can achieveprecise intracellular ... gadolinium complexes may be attached to proteins with multiple disulfide bridges which may yield improved contrast and low detection limit x Chapter Chapter 1.1 Introduction Introduction Metal Complex...

110
698
0

Hướng dẫn thiết kế chi tiết dạng tấm (Sheet metal)

Ngày tải lên : 27/08/2012, 13:54

... môi trờng Sheet Metal: Mở file mẫu Sheet Metal chọn mặt chi tiết file Part, sau chọn Application-> Sheet metal Hệ thống cho phép sử dụng công cụ Sheet Metal bổ sung tham số Sheet Metal tới file ... Sheet Metal Một chi tiết Sheet Metal có tham số mô tả chi tiết cách tạo Ví dụ Sheet Metal thờng có chiều dày mặt uốn cong thờng có bán kính Nút Sheet Metal Styles biểu tợng công cụ Sheet Metal ... đổi kiểu dạng Part Model mặc định thành Sheet Metal Kiểu Sheet Metal chi tiết chi tiết cho phép sử dụng công cụ Sheet Metal bổ sung tham số Sheet Metal Khi ta chuyển lại thành mô hình chi tiết...

10
3.9K
81

The effects of clay a m e n d m e n t and composting on metal speciation in digested sludge liang qiao

Ngày tải lên : 23/09/2012, 14:47

... extracted metals seems to be related to the changes in metal speciation and will be discussed below Metal speciation To determine the effect of red mud on the speciation of metals in sludge, the metal ... of heavy metals Relationship of metal speciation and leachable metal Since a M MgC12 solution is a stronger extractant than a 0.01 M CaC12 solution for metals from cation sites, more metals can ... of metal speciation and plant available metal A comparison between the speciation of metals in the sludge compost and the metals extracted by DTPA is shown in Fig ! It can be seen that the Metal...

14
1K
0

Heavy metal cation retention by unconventional sorbents (red muds and fly ashes)

Ngày tải lên : 23/09/2012, 14:47

... in heavy metal ions removal (Apak and Unseren, 1987) The aim of the present study is to develop costeffective unconventional sorbents, preferably metallurgical waste solids, for heavy metal removal ... needs to be shown so as to guarantee non-leachability of metals from the metal- loaded sorbents EXPEilIMENTAL Materials and methods All heavy metal solutions (divalent cations Of Pb, CA and Cu) were ... heavy metal hydroxide as the elution proceeds, and this layer may promote further binding of the metals enhancing sorption Generally very high limiting capacities have been achieved for metal...

11
513
0

Metal Casting Made Easy

Ngày tải lên : 02/05/2013, 14:44

... guide to hobby metal casting Introduction to the backyard foundry A worldwide hobby metal casting renaissance is occurring, hobbiest’s around the globe are re-discovering the metal casting skills ... to hobby metal casting About the author My interest in metal work stems from my boyhood days, I was fascinated as I watched my father work the farm “Blacksmith Charcoal Forge” to heat metal to ... Complete guide to hobby metal casting DISCLAIMER Foundry work is lots of fun You will get much enjoyment from your metal casting creations, but please take CARE when handling molten metal Temperatures...

98
700
0

Effect of urban emissions on the horizontal distribution of metal concentration in sediments in the vicinity of Asian large cities

Ngày tải lên : 05/09/2013, 09:08

... sampled in the Philippines and its total metal concentration, dissolved metal concentration, and suspended solid concentration were measured to calculate the metal concentration associated with suspended ... heavy metals in the wastewater treatment process Chemosphere, Vol 53, No 10, 1201-1210 Lee, P K., Yu, Y H., Yun S T and Mayer, B (2005) Metal contamination and solid phase partitioning of metals ... concentrations of lead and zinc Table summarizes the results of all the target metals in this study Concentration of metals like copper and nickel other than lead and zinc were distributed in narrow...

11
440
0

Investigation on K2Ti4O9 Whisker Absorbent and Applications in Heavy Metal Ions Removal

Ngày tải lên : 05/09/2013, 09:38

... ion diameters of some heavy metal ions It can be seen from the table that the metal ions are much smaller than the layer distance of the PTW crystal [5] So that the metal ions could rather easily ... with a given content of the metallic ions in water, as the quantity of absorbent (PTW) increases, the active sites of the absorbent increases, which results in more metallic ions absorbed and ... easily penetrate into the crystal layer and substitute K+ ions to form stable metallic/potassium tetratitanates The metal ions would then be removed from the water Table2 Diameters of some Element...

6
437
0

Spatial Variation of Metal Concentrations in Watercourses of an Urban River Basin in Southeastern Brazil

Ngày tải lên : 05/09/2013, 10:15

... initial volume of 10 ml with metal- free water and stored at 4°C The concentration of metals in water was analyzed using an atomic absorption spectrometer The quantification of metals was based upon ... explained by the partition of those metals between the sediment and water column phases Further partitioning of metals occurs within the sediment chemical fractions and metal speciation in the water ... hierarchical CA to (i) classify different areas of the basin according to the concentration of metals and metalloids and (ii) establish natural background levels for the basin MATERIALS AND METHODS...

14
520
1

Application and Comparison of Two Biotic Ligand Models Predicting Copper Toxicity and Accumulation in Heavy Metal Tolerant Moss

Ngày tải lên : 05/09/2013, 10:15

... appropriate modeling and prediction of heavy metal toxicity and accumulation Funaria hygrometrica Hedw is one of the most tolerant mosses to heavy metals (Itouga et al., 2006) Therefore, F hygrometrica ... the heavy metal accumulation in the moss, Michaelis-Menten-type equation (eq 4) was used (Vázquez et al., 1999), [M]moss = n [M] 　 K m + [M] (4) where [M]moss (mg/g d.w.) is the heavy metal accumulation ... accumulation in the moss, n (mg/g d.w.) is the maximum heavy metal accumulation, [M] (mol/L) is the total concentration of heavy metal, and Km (mol/L) is Michaelis constant The observed data...

7
432
0

Numerical simulation and performance test of metal hydride hydrogen storage system

Ngày tải lên : 05/09/2013, 14:58

... The design of metal hydride reactor Metal hydrides have the potential for hydrogen storage and metal hydride reactor provides the space where the materials are filled Using the metal hydride ... transfer in the metal hydride bed By solving the Darcy equation can obtain the diffusion behavior of hydrogen in metal hydride bed The detail thermal modeling and analysis of a metal hydride is ... middle layer (r=rfront) of metal hydride reactor is the position of the hydration front The outer layer (r=router) of metal hydride reactor is responsible for supporting the metal hydride powder and...

14
501
0

Plasmonic Green Nanolaser Based on a Metal SemiconductorStructure

Ngày tải lên : 18/09/2013, 21:26

... the electric-field component is perpendicular to metal surface) and the TE mode (transverse electric; the electric-field component is parallel to metal surface) along the z direction at the lasing ... substrate by plasma-assisted molecular-beam epitaxy (PA-MBE) using a self-organized method without metal catalysts.24 Figure 1a shows the schematic of the plasmonic nanolaser consisting of a green-emitting ... Only the TM mode shows strong confinement in the SiO2 gap layer, while the TE mode extends into the metal, semiconductor, and air regions (b) The electric-field-intensity (TM polarization) distribution...

5
492
0

Water Splitting on Composite Plasmonic-Metal/SemiconductorPhotoelectrodes: Evidence for Selective Plasmon-Induced Formationof Charge Carriers near the Semiconductor Surface

Ngày tải lên : 18/09/2013, 21:27

... molecules play a critical role in separating the metal and semiconductor particles and limiting F€rster energy o transfer between the semiconductor and the metal This is discussed in more detail below ... shape of plasmonic metal nanoparticles and thereby control the energy and intensity of the SPR offers a great deal of flexibility in the design of efficient composite plasmonic -metal/ semiconductor ... observed rate enhancement We previously investigated the interactions between excited plasmonic -metal particles coated with nonconductive molecules and a nearby semiconductor in a nonreactive...

4
464
0

ADC KRONE - Datasheet - Cat 6A - Patch Panel - No metal (New Gen)

Ngày tải lên : 26/10/2013, 18:15

2
312
0

Ý KIẾN NHẬN XÉT VÀ KIẾN NGHỊ NHẰM HOÀN THIỆN CÔNG TÁC KẾ TOÁN NGUYÊN VẬT LIỆU, CÔNG CỤ DỤNG CỤ Ở CÔNG TY VIT-METAL.

Ngày tải lên : 31/10/2013, 22:20

... Vit -Metal Lịch sử hình thành phát triển công ty Vit- Metal 1.2 Sự đời phát triển công ty Vit- Metal 1.3 Tổ chức máy quản lý công ty Vit- Metal 1.4 Chức nhiệm vụ hoạt động công ty Vit- Metal ... ty Vit- Metal Đặc điểm tổ chức công tác kế toán nguyên vật liệu, công cụ dụng cụ công ty Vit Metal 2.1.Hình thức kế toán công ty áp dụng 2.2.Cơ cấu tổ chức máy kế toán công ty Vit- Metal 2.3.Nhiệm ... công cụ dụng cụ công ty Vit- Metal 3.4.1 Thủ tục nhập kho, xuất kho vật liệu, công cụ dụng cụ công ty VitMetal a.Thủ tục nhập kho vật liệu, công cụ dụng cụ công ty Vit- Metal b.Thủ tục xuất kho 3.4.2...

7
523
0

metal for paedo

Ngày tải lên : 06/11/2013, 05:11

... properties of metals Alloys An alloy is a mixture of a pure metal and one or more other elements Often, these other elements are metals For example, brass is an alloy of copper and zinc Metals can ... Metals can also be alloyed with non-metals In many cases, metals are quite soluble in other metals In other cases, instead of a solid-solution a new phase, an “intermetallic compound”, with a structure ... referred to as glasses Metals can usually crystallise even at very high cooling rates, but under extreme conditions metallic glasses can be produced in some alloys NB metallic glasses are not...

74
312
0

Tài liệu Nu Metal là gì? ppt

Ngày tải lên : 11/12/2013, 19:15

... Hát Các ban nhạc Nu metal thường có giọng hát có quãng giọng giống từ pop đến rock, giọng gào từ nhiều dạng metal, hardcore punk và, funk metal, sử dụng rap Một vài khác biệt ... kết hợp) Làm méo giọng vài hiệu ứng thường thêm vào giọng hát nu metal Los Angeles-based quartet Tool xem nguồn gốc vài giọng ca Nu metal; Jonathan Davis Korn, Chino Moreno Deftones, Pete Loeffler ... System of a Down, chịu ảnh hưởng Trung Đông Guitar Không giống Metal truyền thống, nét xác định tổng quan phong cách guitar nhạc Nu metal nhấn mạnh vào tâm trạng, nhịp điệu xếp giai điệu phối hợp...

3
487
0

Tài liệu Metal Machining Theory and Applications ppt

Ngày tải lên : 17/12/2013, 11:15

... Machining (turning, milling, drilling) is the most widespread metal shaping process in mechanical manufacturing industry Worldwide investment in metal- machining machine tools holds steady or continues ... been a decline in investment Over this period, investment in metal machining has remained at about three times the annual investment in metal forming machinery Investment has continued despite perceived ... that has encouraged near-net (casting and forging) process substitution in the metal products sector One reason is that metal machining is capable of high precision: part tolerances of 50 mm and...

416
540
0

Tài liệu METAL FORMING, SHAPING, AND CASTING docx

Ngày tải lên : 17/12/2013, 14:15

... prepared metal surface by dipping or spraying and, after drying, is fired at approximately 1470°F ( ° ) to fuse the material to the metal surface 80C Metallizing Metal spraying, or metallizing, ... applicable only to thermoplastics 34.6 POWDER METALLURGY In powder metallurgy (P/M), fine metal powders are pressed into a desired shape, usually in a metal die and under high pressure, and the ... employs a slow-squeezing action that penetrates throughout the metal and produces a uniform metal flow In hammer or impact forging, metal flow is a response to the energy in the hammer-workpiece...

33
442
4

Tài liệu SHEET METAL CLIP pptx

Ngày tải lên : 22/12/2013, 11:17

... Inside Rad -> Done/Return Pick the front surface of the sheet metal as sketching plane Okay -> Default Pick the top edge of sheet metal as additional reference First, sketch the bend line as shown...

18
350
2

iec 60298 a.c. metal-enclosed switchgear and controlgear for rated voltages above 1 kv and up to

Ngày tải lên : 25/12/2013, 10:57

... more non -metal1 ic.partition.s); 3.102.1 Metal- clad switchgear and controlgear Metal- enclosed switchgear and controlgear inwhich components are arranged in separate compartments with metal partitions ... switchgear and controlgear (with non-metallic partitions) Metal- enclosed switchgear and controlgear in which components are arranged in separate compartments as for metal- clad switchgear and controlgear, ... contained inmetal-enclosed switchgear and controlgear' for which individual specifications exist NOTES Switchgearand controlgear assemblies having an insulation enclosure are covered by I E C 466 Metal- enclosed...

139
465
0