... tensile tests andresidual stress measurements in a mining boom cluster before and after PWHT Experience with the use of incremental hole drilling technique for residual stresses measurements ... tubular welded connection (Figure 1), consisting of 406 mm (16’’) , 19 mm thick main chord and four lacing members of 168 and 219 mm (6’’ and 8’’) OD and mm thickness The parent material for this ... chords) and is often not performed on other civil structures EXPERIMENTAL PROCEDURE 2.1 Material Properties There are many methods ofresidual stress measurements with varying levels of sophistication...
... total of 303 points with 21 residual stress profiles studied Specimens and Welded Panel for Residual Stress Measurements The measurements of welding residual stress were performed for and 15 ... surface residualand applied stresses in samples, parts, welded elements and structures Ultrasonic MeasurementofResidual Stresses Ultrasonic Method ofResidual Stress Measurement One of the promising ... application of ultrasonic technique for residual stress measurement should be of high resolution, reliable and fully computerized Results ofResidual Stress Measurement Stress in direction of longitudinal...
... positive endexpiratory pressure (PEEP) of 0, respiratory set frequency of breaths per minute, and a pause time of 15% VT was increased by increments of 50 ml and the plateau pressure R399 was recorded ... For each set of test conditions (Table 1) we used the mean of the three replicate measurements and also give the highest and lowest values VT was adjusted for the simulated weights and expressed ... each model The standard deviation of the difference was 0– 0.2 ml/kg for all sets of measurements In all models, in the absence of ETT leakage the difference between effective VT and VT measured...
... lightness (L*) and an increase in redness (a*) and yellowness (b*) values of raw WSN sheets from soft and hard wheat flour samples Measurements of L*, a*, and b* usually give low standard deviations ... calculate the gloss and translucency score Panelists ranked noodle gloss and translucency on boiled noodle disks and strands from six WSN mixes of ASWN and gelatin, following standard procedures ... a standard cooked noodle thickness of mm Experiment The effect of water addition and vacuum on color, gloss, and translucency for soft wheat WSN was also examined using ANOVA Translucency and...
... consideration of collateral and margining requirements, and the effect of master netting arrangements See Question 10 for a discussion of the inclusion of credit risk in the valuation of financial ... Audit, Tax and Advisory are specialists in their fields and have deep experience in the issues and needs of investment management businesses We offer professional services to a wide range of industry ... requirements of both IAS 39 (and, where applicable, its interactions with currently effective requirements of IFRS Financial Instruments: Disclosures and IFRS Financial Instruments) and IFRS 13 and explains...
... analyses of kinematics and kinetics using the Selspot/TRACK data acquisition system during standing and locomotion activities, with precision and accuracy of < mm position and < 1° orientation ... viewing volume Subjects' anatomical data were then used to transform the global DOF kinematics to DOF body segment kinematics [24] Body segment mass, center of mass, and mass moment of inertia ... anatomical measurements[23] Segment angular and linear velocities and accelerations were computed by numerical differentiation of segment position data, and used with segment Page of 10 (page...
... median of three measurements was poor to good for the midfoot and hallux (ICCs of 0.54 and 0.72, respectively) and good (ICCs from 0.75 to 0.85) for the total area, heel, MPJ345, MPJ2, MPJ1, and ... median of three measurements was moderate for MPJ345, MPJ2, and the lesser toes (ICCs between 0.69 and 0.71) and good for the total area, heel, midfoot, MPJ1 and the hallux (ICCs between 0.77 and ... two-step, and three-step protocols and an estimate of the number of measurements required Foot Ankle Int 2004, 25:739-744 28 Hughes J, Pratt L, Linge K, Clark P, Klenerman L: Reliability of pressure measurements:...
... genomics analysis of these functional RNAi datasets in breast and ovarian cancer, we have identified regulators of mitotic arrest and ceramide metabolism as mediators of taxane resistance and confirmed ... kinases, respectively The persistent upregulation of VEGF and PDGF in the majority of RCCs through inactivation of VHL fosters angiogenesis and growth of these tumors The multitargeted tyrosine kinase ... distinguished: resistance of the tumor vasculature to the inhibition of VEGF and PDGF signaling (vascular resistance); and resistance of cancer cells to the hypoxic and nutrient-depleted microenvironment...
... first base of the first complete codon, and the last base the last of the final complete codon The first and last codons were then removed from each exon, and remaining codons within 70 bp of the ... number of synonymous SNPs per synonymous site The numbers of synonymous sites and non-synonymous sites were calculated using the method of Miyata and Yasunaga [74] The ratio for a set of proteins ... number of SNPs and the number of sites to obtain A and S for the concatenated set before taking the ratio Volume 9, Issue 4, Article R69 Hurst LD: The Ka/Ks ratio: diagnosing the form of sequence...
... mDCs and moDCs [12] and moDCs and KG-1 cells [13], but no studies have compared the proteomes of all three cell types In this study we compare the proteomes of mDCs, moDCs and KG-1 cells, and ... higher levels of key inflammatory (IL-1β, IL-6 and IL-8) and regulatory (IL-10) cytokines, compared to moDCs and KG-1 cells Levels of IL-1β, IL-6, IL-8 and IL-10 were dose dependent, and following ... presence of × 104 irradiated (3,000 rad 137Cs) immature mDCs and interactions Figure Cytokine expression profiles of cells Cytokine expression profiles of cells Cytokine production by mDCs and the...
... studied and developed Due to various techniques and the lack of standardization, in 1988, the Committee for Head and Neck Surgery and Oncology of the American Academy of Otolaryngology-Head and Neck ... (I.e how B is a subset of A and C is a subset of B.) xxv Introduction and Background Cancer remains one of the leading causes of morbidity and mortality worldwide Oral and pharyngeal cancers ... appreciation to Associate Professor Wong Wai Keong, Head of the Department of General Surgery, Singapore General Hospital and Associate Professor Koong Heng Nung, Head of the Department of Surgical Oncology,...
... control) and also with the lower tidal volumes usually used during ARDS Figure pliance of the respiratory system (Crs) Correlation between functionalresidualcapacity (FRC) and static compliance of ... at a PEEP of cm H2O (p < 0.05) Correlation between PaO2 and FRC (Figure 2), and between PaO2 and Crs (Figure 3) were significant (p < 0.05) but weak drome the of induction residualcapacity a ... best value of PEEP should allow for the tidal excursion to be positioned between derecruitment and overdistension on the pressurevolume curve Key messages ● Functionalresidualcapacity measurement...
... Page of 11 Figure Influence of intra-abdominal pressure and positive end-expiratory pressure on functionalresidualcapacityFunctionalresidualcapacity (FRC) in litres (L) in function of different ... the effect of different levels of PEEP in the setting of different levels of IAP on lung volumes assessed by FRC and CO parameters in a healthy pig model Effect of IAP and PEEP on FRC, and PaO2 ... IAP and 0.2 (0.1) L ((20 (11)%) at IAP 18 cmH2O Effect of IAP on CO, DO2, SvO2, and SVR IAH did not significantly change CO and DO at cmH2O of PEEP (Figures and 3, and Tables 1, and 3) Effect of...
... properties of denture base material related to the effect of level ofresidual monomer, and concluded that the percentage of higher levels ofresidual monomer effected on the tensile properties of denture ... hardness and the weight percentages of the insoluble parts The mean domain size and the volume fraction of the rubber phase favor that of the water-bath cured specimens Naik and Jabade4 evaluated and ... in previous section RESULTS AND DISCUSSION 3.1 Residual Monomer Test (HPLC) Figures and show the diagram ofresidual MMA collected from g sample of PMMA for heat-cure and self-cure denture base...
... larger than mm (4 mm, mm and mm) in any of the three directions will be set to zero and then saved in a new data set named mmresidual (4 mmresidual, mmresidual and mmresidual) For example, if ... 2.4, and 1.7 mm and random errors were 2.4, 2.9 and 2.2 mm in the LR, SI and AP directions, respectively [20], which made the total setup margins of 8.4 mm, 8.0 mm and 5.8 mm in the LR, SI and ... from the first registration were 3.5, and mm in the LR, SI and AP directions respectively, the mmresidual would be 0,0 and mm and the mmresidual would be 3.5,0 and mm (3) Register the post-treatment...
... design and for the drafting of the manuscript FG and SL were responsible funding of the chemicals used in the study, the sourcing of the instruments from community podiatry and the CDU and for ... centralisation of sterile services and the reprocessing of instruments at a central decontamination unit (CDU) [7] CDU’s offer the advantages of validated modern equipment, specialist knowledge, and shifts ... statistical analysis and aided in study design GR and AJS were responsible for the overall design of the study and aided in the final drafting of the manuscript All authors have read and approved the...
... fitting of linear mixed models in order to estimate genetic and phenotypic variation or to predict the genetic merit of selection candidates Measurement errors and other sources of random non-genetic ... i, m )’ is a vector of phenotypic values of animal i for m traits, b is a vector of fixed effects, a is a vector of random genetic effects, h is a vector of uncorrelated random effects such as ... and BSt models, using ⎟ E BW ⎠ ( ) R E = R and R E = R where ν > 2, respectively, − given by Stranden and Gianola [4] and Cardoso et al [7] Heritabilities and genetic correlations are of...
... blank The Works of Archimedes Archimedes was the greatest scientist of antiquity and one of the greatest of all time This book is Volume I of the first fully fledged translation of his works into ... following note on purpose and practices of the critical edition of diagrams 2.3 Purpose and practices of the critical edition of diagrams The main purpose of the critical edition of diagrams is to reconstruct ... conservator of manuscripts, Abigail Quandt, to the imagers of the manuscript, especially Bill Christens-Barry, Roger Easton, and Keith Knox and finally, and most importantly, to the anonymous owner of...
... the flow from the bottom of the packed bed column to the bottom of the UCBR column The geometry of the UCBR and packed bed column are given in Table Table Geometry of UCBR and Packed Bed column ... experiment pH of the reactor was maintained at 7.5 + 0.3 with manual addition of acid (HCl) and base (NaHCO3) Approximately 15 ml of biofilm particles was taken from the UCBR to inoculate L of synthetic ... in accordance with Standard Methods for Water and Wastewater (APHA, 1995) DO and pH were recorded at each sample collection interval MLSS concentration, particle size and biofilm density were determined...
... bene ts of abstraction in a functional language This article assumes no knowledge of JPEG or any of its algorithms, nor of specialized functional programming techniques Basic knowledge offunctional ... the standard prelude of most languages In section matrix manipulation, bit lists and binary trees are dealt with In section the notions of `state function' and `monad' are introduced, and some ... article, we will use standard functions on lists, like map, concat, zipWith and transpose These functions are de ned in the standard prelude of most functional languages Six functions of general nature...