0

low power rtl design coding techniques

Advanced techniques in RF power amplifier design

Advanced techniques in RF power amplifier design

Điện - Điện tử

... C.Advanced techniques in RF power amplifier design.  (Artech Housemicrowave library)1. Power amplifiers Design 2. Amplifiers, Radio frequencyI. Title621.38412ISBN 1-58053-282-9Cover design ... the Class B (zero bias) point, an increase of drive6 Advanced Techniques in RF Power Amplifier Design Input power (2 dB/div)Output power (2 dB/div)PlinVq= 0.5 (Class A)0.250.150.05Vq= ... resonate16 Advanced Techniques in RF Power Amplifier Design 1Class AB Amplifiers1.1 IntroductionThe Class AB mode has been a focus for several generations of power ampli-fier designers, and for...
  • 339
  • 489
  • 0
ultra low-power electronics and design

ultra low-power electronics and design

Đại cương

... to proposals on other levels in the design flow and to future work. Keywords: Low- power design, dynamic power reduction, leakage power reduction, ultra- low- Vth devices, multi-Vdd, multi-Vth, ... Pacific Design Automation Conference 2003, pp. 400-403. [20] K. Usami, M. Horowitz, Clustered Voltage Scaling Technique for Low- Power Design, Proceedings of the International Symposium on Low Power ... dynamic power by 15% was achieved for a 0.18àm process technology. Leakage power was reduced by 40%. As leakage power was more than 1000x smaller than dynamic power, overall active power reduction...
  • 290
  • 1,091
  • 0
A low power high dynamic range broadband variable gain amplifier for an ultra wideband receiver

A low power high dynamic range broadband variable gain amplifier for an ultra wideband receiver

Tiến sĩ

... obtain large variable gain ranges under low supply voltage. II.2 Comparison of the commonly used VGA structures The design requirements impose challenges on low power consumption, very large bandwidth, ... suitable for low power applications. (3) Summary of analog-multiplier-based VGA In summary, the multiplier-based VGA has good linearity and large gain tuning range, but it is not power efficient ... generated by the subtraction between gmp1 and gmp2. And hence, it is not suitable for low- power VGA design. II.1.3 Differential pair with source degeneration Another commonly used VGA topology...
  • 121
  • 386
  • 0
Tài liệu Low-Power, Slew-Rate-Limited RS-485/RS-422 Transceivers doc

Tài liệu Low-Power, Slew-Rate-Limited RS-485/RS-422 Transceivers doc

Điện - Điện tử

... Typical Half-Duplex RS-485 Network Low- Power Shutdown Mode(MAX481/MAX483/MAX487)A low- power shutdown mode is initiated by bringingboth RE high and DE low. The devices will not shutdown unless ... MAX1487are designed for half-duplex applications.________________________Applications Low- Power RS-485 Transceivers Low- Power RS-422 TransceiversLevel TranslatorsTransceivers for EMI-Sensitive ApplicationsIndustrial-Control ... CURRENT vs.RECEIVER OUTPUT LOW VOLTAGE525MAX481-01OUTPUT LOW VOLTAGE (V)OUTPUT CURRENT (mA)1.515100.5 1.0 2.0203540450.90.1-50 -25 25 75RECEIVER OUTPUT LOW VOLTAGE vs.TEMPERATURE0.30.7TEMPERATURE...
  • 20
  • 504
  • 0
power electronics design guide

power electronics design guide

Điện - Điện tử

... 205Table F.1 Foreign Technical Words 239 Power Electronics Design: A Practitioner’s Guide 15 Chapter 2 Power Apparatus Much of the design work in power electronics involves specificationof ... uninterrupted power tothese facilities. One system that is gaining acceptance is to utilize fuelcells operating on natural gas to generate DC power. This power canthen be converted to AC with power ... circuit as the contactorcloses. 41 ◊ Electric Power power by industry. The induction motor required no elaborate startingmeans, it was low in cost, and it offered important advantages in...
  • 272
  • 328
  • 0
Báo cáo khoa học:

Báo cáo khoa học: "Crossed Serial Dependencies:i low-power parseable extension to GPSG" ppt

Báo cáo khoa học

... each VP rule which introduces a VP complement, allowing the verb to be lowered onto the complement. As this rule must also expand VPs with verbs lowered onto them, we want e.g. cii) vPlz -> ... (I) will apply to all three of (B) - (D), allowing compound verbs to be discharged at any point. (II) will apply to (B) and (C), allowing the lowering (with compounding if needed) of verbs ... Even in the weakest augmentation, allowing only one occurence of one variable over sequences in any constituent of any rule, the apparent similarity of their power remains to be formally established,...
  • 6
  • 261
  • 0
Báo cáo Y học: Effect of adenosine 5¢-[b,c-imido]triphosphate on myosin head domain movements Saturation transfer EPR measurements without low-power phase setting ppt

Báo cáo Y học: Effect of adenosine 5¢-[b,c-imido]triphosphate on myosin head domain movements Saturation transfer EPR measurements without low-power phase setting ppt

Báo cáo khoa học

... with low concentration of spin labels shouldbe detected. At low concentration of spin labels where highreceiver gain is required to obtain a spectrum of goodquality, it is difficult to follow ... that at low microwave power the variance of theEPR signal would be minimum over the whole field scan atthe out-of-phase setting, the correct phase angle can becalculated from two high -power spectra ... nucleotide reporteddisorder. The low- angle X-ray diffraction patterns weremodified by AdoPP[CH2]P in insect flight muscle; the ratioof the two inner equatorial peaks was lowered when theconcentration...
  • 10
  • 563
  • 0
High-performance, Low-power Atmel® AVR® 8-bit Microcontroller.

High-performance, Low-power Atmel® AVR® 8-bit Microcontroller.

Tin học

... Time from Power- down and Power- saveAdditional Delayfrom Reset (VCC = 5.0V) Recommended Usage00 18 CK – BOD enabled01 18 CK 4.1 ms Fast rising power 10 18 CK 65 ms Slowly rising power 11 ... Time from Power- down and Power- saveAdditional Delay from Reset (VCC = 5.0V) Recommended Usage00 6 CK – BOD enabled01 6 CK 4.1 ms Fast rising power 10(1)6 CK 65 ms Slowly rising power 11 ... 382466T–AVR–07/10ATmega16(L)Figure 15. Reset LogicNotes: 1. The Power- on Reset will not work unless the supply voltage has been below VPOT (falling).2. VBOT may be below nominal minimum operating voltage for...
  • 357
  • 6,024
  • 0
brown, m. (1990). practical switching power supply design

brown, m. (1990). practical switching power supply design

Điện - Điện tử

... of the power In order to adequately approach a switching power supply design, the designer must have a reasonable understanding of the major subsections that make up a switching power supply. ... I I5 9. I Power Supply and System Grounds I 15 9.2 The Use and Design of Clamps and Snubbers 9.3 RFI and EM1 Design Considerations 125 i07 109 Ill I I9 9.4 Power Supply and ... major power supply parame- ters as a preliminary guide at the beginning of a switching power supply 4.3 Transformer-Isolated Switching Power Supply Topologies 29 As in all power...
  • 258
  • 520
  • 0
self, d. (2002). audio power amplifier design handbook (3rd ed.)

self, d. (2002). audio power amplifier design handbook (3rd ed.)

Điện - Điện tử

... it is said that discrete power amplifier design is ratherunenterprising, given the enormous outpouring of ingenuity in the design ofanalogue ICs. Advances in op-amp design would appear to be ... publ.Addison-Wesley, p. 310.28 Audio Power Amplifier Design HandbookSolid-state gives much more freedom of design; all of the amplifier classesbelow have been commercially exploited. Unfortunately, ... Power Amplifier Design HandbookThird editionDouglas Self MA, MScNewnesOXFORD AMSTERDAM BOSTON LONDON NEW YORKPARIS SAN DIEGO SAN FRANCISCO SINGAPORE SYDNEY TOKYO Audio Power Amplifier Design...
  • 444
  • 881
  • 0
audio power amplifier design handbook [electronic resource]

audio power amplifier design handbook [electronic resource]

Đại cương

... solid-state power amplifi er design. The fi rst aim of this text is to fi ll that need, by providing a detailed guide to the many design decisions that must be taken when a power amplifi er is designed. ... done on amplifi er design in the last few years. The unexpected result of these investigations was to show that power amplifi ers of extraordinarily low distortion could be designed as a matter ... The techniques are conventional; the last stereo power amplifi er I designed managed an easy Ϫ 90 dB at 10 kHz without anything other than the usual precautions. In this area dedicated followers...
  • 608
  • 1,988
  • 0
báo cáo hóa học:

báo cáo hóa học:" Effects of low power laser irradiation on bone healing in animals: a meta-analysis" pptx

Hóa học - Dầu khí

... potential role for low- power laser across differ-ent constructs. However, this study d id define the needfor additional biomechanical research to identify therole for low- power laser across ... Mayayo E: Bone fracture consolidate faster with low power laser. Lasers Surgical Medicine 1987, 7(1):36-45.19. Yamada K: Biological effects of low power laser irradiation on clonalosteoblastic ... indicate that low power laser irradiation can enhance biomechanical properties of bone duringfracture healing in animal models. Maximum bone tolerance was statistically improved following low level...
  • 10
  • 365
  • 0
Báo cáo hóa học:

Báo cáo hóa học: "Two novel low-power and high-speed dynamic carbon nanotube full-adder cells" pdf

Hóa học - Dầu khí

... 90% lower than the design in [6], 81% lower thanthe design in [13], 82% lower than the design in [14], and3% lower than the design in [15].Proposed multi-output dynamic full adder is 7% slowerthan ... 2% slower tha nthe design in [6], 39% slower than the design in [14], and21% faster than the design in [13]. Among the existingfull adders, the power consumption of our proposed low- power ... the design in [6], 26% faster than the design in [13],36% slower than the design in [14], and 43% slower thanthe design in [15]. This proposed full adder consumes 91%less power than the design...
  • 7
  • 928
  • 0

Xem thêm