... 2.5 min 80oC, 3.0 min
90oC, 2.5 min 90oC, 3.0 min
Reference
OM2717
0
10
20
30
40
50
60
0 20406080
Tempering time, min
Breaking force, N
80oC, 2.5 min 80oC, 3.0 min
90oC, 2.5 min 90oC, 3.0 min
R
e
f
e
r
e
n
ce
... design, consisting of two levels of drying temperature (80 and 90
0
C), two
levels of drying time (2.5 and 3.0 min) and four levels of tempering time (0, 30, 40, and 60 min),
was chosen in this experiment. ... determination
The moisture contents before and after tempering and final moisture content after thin layer drying
of each drying run were determined by drying 5-10 gram of rough rice (in duplicate)...
... analysis of centerless grinding, ASME Journal of
Engineering for Industry 87 (1964) 163–174.
[2] W.B. Rowe, F. Koenigsberger, The ‘‘work-regenerative’’ effect in
centreless grinding, InternationalJournal ... components in z direction.
The FRFs obtained in the analysis were studied in LMS
Cada-X software, obtaining 10 natural frequencies, mode
shapes and damping factors in the frequency range of
interest.
2.3. ... conditions, givin g an insight into
the real behavior of different components.
2.1. FE model
Dynamic characteristics of centerless grinding machine
were studied by means of a FE model using ANSYS
software....
... Barrenetxea
c
a
Faculty of Mining Engineering, Department of Mechanical Engineering, University of the Basque Country, Colina de Beurko s/n, 48902 Barakaldo, Spain
b
Faculty of Engineering, Department of Mechanical ... Uribe-Etxeberria,
J.M. Herna
´
ndez, An active system of reduction of vibrations in a centerless
grinding machine using piezoelectric actuators, InternationalJournal of
Machine Tools and Manufacture 47 (10) (2007) ... Dynamic model of a centerless
grinding machine based on an updated FE model, InternationalJournal of
Machine Tools and Manufacture 48 (7–8) (2008) 832–840.
[10] D.R. Martinez, T.D. Hinnerichs,...
...
Member of the SME, ASME, SCC, and PDMA.
Chiwei Lin is an Assistant Professor in Department
of Industrial Engineering and Management, Ming
Hsin University of Science and Technology, Hsinfeng, ... Technology in
2003, he worked as a researcher in Mechanical
Industry Research Laboratories (MIRL), The
Industrial Technology Research Institute (ITRI),
Hsinchu, Taiwan. His research interests include ... Engineering Management
National Tsing Hua University
Hsinchu (300), Taiwan
2
Department of Industrial Engineering and Management
Ming Hsin University of Science and Technology
Hsinfeng (304),...
...
âAACSB International
Regarding research
expectations, AACSB
International s accreditation
standards have not been
immune to criticism.
Final Report of the
AACSB International
Impact of
Research ...
proceedings or online journal is acceptable evidence of intellectual contribution or how active
involvement in consulting is the “functional equivalent” ofresearch and more consistent with
institutional ... that maintain the currency and
relevance of their instruction … through a variety of efforts, including production of intellectual
contributions, professional development, and current professional...
... 20097, Milan, Italy
Full list of author information is available at the end of the article
Maria et al. InternationalJournalof Emergency Medicine 2011, 4:13
http://www.intjem.com/content/4/1/13
â ... atic because
of the rarity of the disease. Staging studies include chest,
abdominal, and pelvic computed tomography.
The difficulty of predicting the prognosis and clinical
behavior of hemangiopericytomas ... subset of soft tissue sarcomas. They rarely originate in the spleen as a
primary tumor, with only ten cases having been previously described. The difficulty of predicting the prognosis
and clinical...
... online
7 High visibility within the fi eld
7 Retaining the copyright to your article
Submit your next manuscript at 7 springeropen.com
Cooney and Cooney InternationalJournalof Emergency Medicine ... the foot in a diabetic patient treated with tea tree oil.
International Journalof Emergency Medicine 2011 4 :14.
Submit your manuscript to a
journal and benefi t from:
7 Convenient online submission
7 ... sensation.
Ulceration in areas of increased pressure is also common.
Usually offloading, debridement, advanced wound care
* Correspondence: cooneyd@upstate.edu
Department of Emergency Medicine, Division of Hyperbaric...
... acetylcholinesterase at sites of cholinergic
transmission and enhancing cholinergic action. Side
effects of neostigmine that may cause significant pro-
blems during acute management incl ude increased
abdominal ... monitoring
should be utilized during and after administration of
this drug. The dose for neostigmine is 2 mg intrave-
nously over 3-5 min with a cost of less than $10/dose.
In a double-blinded ... online
7 High visibility within the fi eld
7 Retaining the copyright to your article
Submit your next manuscript at 7 springeropen.com
Cooney and Cooney InternationalJournalof Emergency Medicine...
... are adequately trained and if continuous repe-
titions of relevant training information are offered and
used [12]. Introducing CPR training in high school and
university settings has been widely ... practice.
In the curriculum of first year students at the Faculty
of Medicine and the Faculty of Health Sciencesin Mari-
bor, formal BLS training as a BLS module course and
practical training in other ... monitoring of the quality of instruc-
tions, awareness of instructors when inadequate CPR is
demonstrated and feedback should be integrated into the
training to ensure optimal performance in a...
... thromboplastin time of 41.1 s (22-
35 s), prothrombin time of 18.8 s (11-16 s), and fibrino-
gen of 0.9 g/l (1.5-4 g/l). Urinalysis showed no haemo-
globinuria suggestive of myoglobinuria.
His ... Submit your next manuscript at 7 springeropen.com
Ting and Dehdary InternationalJournalof Emergency Medicine 2011, 4:20
http://www.intjem.com/content/4/1/20
Page 4 of 4
CAS E REP O R T Open Access
Acute ... Brisbane
4101, Australia
Ting and Dehdary InternationalJournalof Emergency Medicine 2011, 4:20
http://www.intjem.com/content/4/1/20
â 2011 Ting and Dehdary; licensee Spring er. This is an Open...
... Cutting
Threshing
Cleaning
Grain moisture contain determination
Packing
Transfering into room
Drying at low temperature
Packing, samples coding
Transferring into ... methods for
harvesting: use serrated blades for cutting plants, gathering before pushing into threshing
machine instead of using windrower cutter or combine harvester. So losses in field are most ... Procedure of experiment in field
Rice field selecting
Blocks dividing
Manual cutting
Threshing
Cleaning up
Moisture determining
Packaging
Drying at ambient temperature
Packaging,...