0

cement portland blast furnace slag—

CO2 emission optimization for a blast furnace considering plastic injection

CO2 emission optimization for a blast furnace considering plastic injection

Môi trường

... Calculation of blast furnace gas volume and its composition content* symbol introduction volume of H2 in blast furnace gas volume of CO in blast furnace gas volume of CO2 in blast furnace gas volume ... volume content of CO within blast furnace gas (%), and ωCO ,bfg is the volume content of CO2 within blast furnace gas (%) 2.4 Constraint conditions The process of blast furnace iron-making must ... optimization model for a blast furnace 2.1 Physical model As shown in Figure 1, a physical model of a blast furnace is considered based on the temperature characteristics inside the blast furnace and some...
  • 16
  • 261
  • 1
Establishment of Advanced Recycling Technology  for Waste Plastics in Blast Furnace †

Establishment of Advanced Recycling Technology for Waste Plastics in Blast Furnace

Tổng hợp

... Anticipating enforcement of the Container and Packaging Recycling Law, JFE Steel began use of industrial waste plastics as blast furnace feed in 1996, and began a waste plastics blast furnace recycling ... the waste plastics used in blast furnaces consist of crushed plastics and granulated plastics, in both cases with a size of 10 mm or less Using the function of the blast furnace raceway, these are ... of Advanced Recycling Technology for Waste Plastics in Blast Furnace Development of Waste Plastics Pulverization Technology Recent blast furnace operation has been characterized by high production...
  • 7
  • 343
  • 0
Designation: C 115 – 96a - Fineness of Portland Cement by the Turbidimeter1 pps

Designation: C 115 – 96a - Fineness of Portland Cement by the Turbidimeter1 pps

Kiến trúc - Xây dựng

... viscosity of kerosine at the temperature of calibration, P, r1 density of cement particles, Mg/m3(g/cm3) 3.15 for portland cement (Note 4), C 115 intensity until equilibrium is established at this ... in many instances in selecting the size of sample: 0.25 g for normal fineness cements and 0.20 g for high fineness cements Calibration 7.1 Calibration of Turbidimeter—Calibrate the turbidimeter ... line Permissible Variation, cm 38 1.9 17.5 0.09 64 60.2 62.5 60.005 61 NOTE 4—The density of portland cement does not vary greatly and in this work it is considered constant at 3.15 A variation...
  • 7
  • 483
  • 0
Designation: C 265 – 99 - Calcium Sulfate in Hydrated Portland Cement Mortar1 pptx

Designation: C 265 – 99 - Calcium Sulfate in Hydrated Portland Cement Mortar1 pptx

Kiến trúc - Xây dựng

... hydraulic cement mortars, because no reference samples are available 14 Keywords 14.1 calcium sulfate; hydraulic cement; sulfate content C 265 For additional useful information on details of cement ... precipitated 12.2 Report the average of the two tests 10 Preparation of Cement Extract 10.1 At 241⁄4h after the instant the cement and water were mixed together, remove the containers successively ... two properly conducted tests by the same operator on water-extractable SO3 in hardened hydraulic cement mortars of the same material should not differ from each other by more than 0.22 g/L SO3...
  • 3
  • 286
  • 0
Designation: C 359 – 99 - Early Stiffening of Portland Cement (Mortar Method)1 pot

Designation: C 359 – 99 - Early Stiffening of Portland Cement (Mortar Method)1 pot

Kiến trúc - Xây dựng

... 10 Procedure 10.1 Batch—Mix at one time 600 g of cement, 300 g of graded standard sand, 300 g of 20-30 standard sand, and 180 mL of water for all cements except Types III and IIIA, for which the ... test method NOTE 2—For additional useful information on details of cement test methods, reference may be made to the “Manual of Cement Testing,” which appears in the Annual Book of ASTM Standards, ... Annual Book of ASTM Standards, Vol 04.01 13 Keywords 13.1 early stiffening; false set; flash set; portland -cement mortar The American Society for Testing and Materials takes no position respecting the...
  • 3
  • 352
  • 0
Designation: C 452 – 95 - Potential Expansion of Portland-Cement Mortars Exposed to Sulfate1 pps

Designation: C 452 – 95 - Potential Expansion of Portland-Cement Mortars Exposed to Sulfate1 pps

Kiến trúc - Xây dựng

... shall be 400 g (cement plus gypsum) and 1100 g of sand The amount of mixing water shall be 194 mL for all non-airentraining portland cements and 184 mL for all air-entraining portland cements 9.2 ... every 28 days thereafter (2) where: c SO3 content of the portland cement, %, g SO3 content of the gypsum, %, and 7.0 SO3 content of the cement- gypsum mixture, % 6.3 If the SO3 content of the gypsum ... RR: 001–1004 C 452 For additional useful information on details of cement test methods, reference may be made to the “Manual of Cement Testing,” which appears in the Annual Book of ASTM Standards,...
  • 3
  • 354
  • 0
slag cement in concrete and mortar

slag cement in concrete and mortar

Cơ sở dữ liệu

... uniform blend of portland cement and granulated blast- furnace slag, portland cement, and pozzolan, or portland blast- furnace slag cement and pozzolan, produced by intergrinding portland cement clinker ... containing portland blast- furnace slag cement and concrete containing slag cement as a separate constituent In Mather’s 1957 study comparing Type II cement concrete with portland blast- furnace slag cement ... intimately interground mixture of portland -cement clinker and granulated blast- furnace slag or an intimate and uniform blend of portland cement and fine granulated blast- furnace slag in which the amount...
  • 19
  • 312
  • 0
guide to portland cement plastering

guide to portland cement plastering

Cơ sở dữ liệu

... the total thickness The traditional materials include portland cement or blended cement and lime, masonry cement, and plastic cement Portland cement- based plaster may be applied by hand, or pumped ... Table 10.3 -Portland cement plasters1 (UBC, Table 47-F)* Portland cement plaster Coat Volume cement Maximum weight (or Maximum volume volume) lime per sand per volume cement3 volume cement2 Approximate ... at the nozzle Plastic cement- Special cement manufactured expressly for the plaster industry Portland cement plaster-Plaster with portland cement used as part or all of the cementitious material...
  • 28
  • 267
  • 0
guide for selecting proportions for high-strength concrete with portland cement and fly ash

guide for selecting proportions for high-strength concrete with portland cement and fly ash

Cơ sở dữ liệu

... cement should equal the weight of cementitious materials calculated in Step Volume of fly ash-Due to the differences in bulk specific gravities of portland cement and fly ash, the volume of cementitious ... WITH PORTLAND CEMENT AND FLY ASH 211.4R-7 Table 4.3.5(a)- Recommended maximum w/(c + p) for 4.3.6 Step 6-Calculate content of cementitious material concretes made without HRWR -The weight of cementitious ... made with portland cement as the only cementitious material The following steps w/(c + p) should be followed to complete the basic mixture proportion I Maximum-size coarse aggregate, in Cement content-For...
  • 13
  • 387
  • 0
Comparison of the physical properties and sealing ability of MTA and portland cement

Comparison of the physical properties and sealing ability of MTA and portland cement

Tổng hợp

... ProRoot MTA, White Portland Cement and Ordinary Portland cement To compare the compressive strength of White MTA, ProRoot MTA, White Portland cement and Ordinary Portland cement To compare the ... Definition of Portland cement Composition of Portland cement Cement production Cement hydration ` iii 2.5.6 2.6 2.7 2.9 Types of Portland cement 37 Cement Admixtures 38 2.6.1 2.6.2 2.6.3 2.6.4 ... admixtures of Portland cement - 30 - 2.5.2 Definition of Portland cement A cement is a material which binds together solid bodies, or aggregates, by hardening from a plastic state (99) Portland cement...
  • 139
  • 320
  • 0
Báo cáo y học:

Báo cáo y học: "Treatment of proximal femur infections with antibiotic-loaded cement spacers"

Y học thưởng thức

... [1] The bone cement used in all cases was Refobacin-Palacos ® (Fa Merck, Darmstadt, Gemany), each spacer was loaded with g vancomycin (Fa cell pharen GmbH, Hannover, Germany) per 80 g cement In ... shortening and provision of sufficient infection therapy is the usage of temporary, antibiotic-loaded cement spacers [5, 7, 14, 24] Although their indication in the treatment of destructive, bacterial ... loaded only with gentamicin Therefore, the addition of an antibiotic to PMMA is required for enhancement of the antibiotic therapy which is possible using our treatment option To our knowledge,...
  • 7
  • 579
  • 0
Tách sóng mimo-v-blast đa người dùng

Tách sóng mimo-v-blast đa người dùng

Công nghệ thông tin

... thut: V -BLAST/ ZF Gii thut: V -BLAST/ LLSE Gii thut: V -BLAST/ ZF/MAP Gii thut: V -BLAST/ LLSE/MAP Xõy dng chng trỡnh mụ phng kờnh MIMO, v tỏch súng MIMO-V -BLAST gm: V -BLAST/ ZF; V -BLAST/ LLSE; V -BLAST/ ZF/MAP; ... súng V -BLAST Gk bk Cu trỳc ca mỏy thu truyn thng cho h thng V -BLAST a ngi dựng 40 MIMO-VBLAST kt hp a ngi dựng Anten thu Rx #1 Ngõn hng b tng quan T = R-1 Tỏch súng V -BLAST G1 Tỏch súng V -BLAST ... Kờnh pha inh V -BLAST/ LLSE; H V -BLAST/ ZF/MAP; n(t) V -BLAST/ LLSE/MAP So sỏnh m li Mụ hỡnh mụ phng h thng MIMO -VBLAST 45 Gii thut tỏch ký hiu cho kờnh MIMO Gii thut tỏch súng V -BLAST (Vertical...
  • 77
  • 722
  • 5
THE VIETNAM CEMENT INDUSTRY – COMPETITION AND CONSUMPTION

THE VIETNAM CEMENT INDUSTRY – COMPETITION AND CONSUMPTION

Quản trị kinh doanh

... Another foreign cement producer that is nearer is Siam Cement Group (Thailand) The company has three major ranges of cement products: Grey Cement, White Cement, and Dry Mortar The White Cement consists ... product is Portland cement In addition, the company produces a variety of specialty cements and cementitious materials (fly ash and gypsum, for example) Types of cement include Portland, low-alkali, ... tons of cement per year, including sorts of PC30, PC40, sulfur long-lasting Portland cement and white cement labeled Blue Dragon It also undertakes transporting raw materials used for cement and...
  • 55
  • 474
  • 0
Waste Management Technologies in Japanese Cement Industry - from Manufacturing to EcofactuaringTM

Waste Management Technologies in Japanese Cement Industry - from Manufacturing to EcofactuaringTM

Môi trường

... utilized in the Japanese cement industry, and figure shows a flow of various kinds of waste in the cement plant (1) Blast Furnace Slag Since the dawn of its inception, the Japanese cement industry has ... Soot Coal Storage Blast Furnace Slag & Coal Ash Cement Mill Cement Silo Shipment Fig Flow of utilization of various kinds of waste as alternative raw materials and fuel in the cement plant (5) ... of waste utilized in the Japanese cement industry at 2000 Waste Blast Furnace Slag Coal Ash By-product Gypsum Low Quality Coal from Mine Non-iron Slag Revolving Furnace Slag Sludge etc Soot & Dust...
  • 6
  • 541
  • 0
Anchorage and resistance to uprooting forces of eelgrass (Zostera marina L.) shoots planted in slag substrates

Anchorage and resistance to uprooting forces of eelgrass (Zostera marina L.) shoots planted in slag substrates

Môi trường

... 129-136 Hizon-Fradejas A.B., Nakano Y., Nakai S., Nishijima W and Okada M (2009) Evaluation of blast furnace slag as basal media for eelgrass bed J Hazard Mater., doi:10.1016/j.jhazmat.2008.12.037...
  • 11
  • 295
  • 0
Experimental investigations and CFD study of temperature distribution during oscillating combustion in a crucible furnace

Experimental investigations and CFD study of temperature distribution during oscillating combustion in a crucible furnace

Môi trường

... of the furnace can be obtained by optimizing the arrangement of the designated points in the furnace combustor according to the experimental measurements and numerical results to make the furnace ... reheat furnace Joint International Combustion Symposium 2001: 5: 217-240 [4] Luis Felip Verdeja, Roberto Gonzales and Alejandro Ordonez Using FEM to determine temperature distribution in a blast furnace ... methodology for overall improvement performance of an aluminum foundry furnace Overall Equipment Effectiveness (OEE) of an oil fired furnace which is a metric for total productive maintenance initiative...
  • 14
  • 590
  • 1

Xem thêm