cells modules and arrays

Electrical Wiring Residential 17 edition (2012)

Ngày tải lên : 15/02/2016, 16:52

... clearly and logically to analyze and solve problems, ability to work indoors and outdoors, comfortable working with your head and hands, good mechanical skills, ability to communicate and work ... experience, and technical knowledge to wire for, install, and repair electrical apparatus and equipment for light, heat, power, and other purposes, in accordance with standard rules and regulations ... found in NFPA 70E and in the ANSI Standard Z535.4, Product Safety Signs and Labels TIP: When turning a standard disconnect switch “ON,” don’t stand in front of the switch Instead, stand to one side...

836
1.8K
2

Báo cáo khoa học: "User Requirements Analysis for Meeting Information Retrieval Based on Query Elicitation" pdf

Ngày tải lên : 23/03/2014, 18:20

... Nicholas C Romano Jr and Jay F Nunamaker Jr 2001 Meeting Analysis: Findings from Research and Practice In Proceedings of HICSS-34, Maui, HI, IEEE Computer Society Alexander Clark and Andrei Popescu-Belis ... Retrieval Addison Wesley Satanjeev Banerjee, Carolyn Rose and Alexander I Rudnicky 2005 The Necessity of a Meeting Recording and Playback System, and the Benefit of Topic-Level Annotations to Meeting ... Meetings In Proceedings of MLMI 2004, Martigny, Switzerland Stéphane Marchand-Maillet and Eric Bruno 2005 Collection Guiding: A new framework for handling large multimedia collections In Proceeding...

8
378
0

swimming pools 4ed philip h perkins 2

Ngày tải lên : 23/03/2014, 20:36

... (sand) for mortars and external rendering are BS 1199 and BS 1200 1976/1996, and these cover sand for mortar for plain and reinforced brickwork, blockwork and masonry The Standards should be referred ... British Standard for concreting aggregates, which is still valid at the time of writing, is BS 882, and covers gravel, crushed rock and sand The British Standards for fine aggregate (sand) for ... Portland cement and pulverised fuel ash (pfa) and Portland cement and ground granulated blast furnace slag (ggbs) are used in concrete for special purposes such as reduction of heat of hydration and...

234
894
1

requirements engineering for sociotechnical systems

Ngày tải lên : 06/07/2014, 15:27

... Centre of Finland, VTT Electronics, Finland Maarit Tihinen, VTT Technical Research Centre of Finland, VTT Electronics, Finland Marco Lormans, Delft University of Technology, The Netherlands Rini ... Melby, and Seland, proposes observational studies and drama improvisation as a means to identify and analyze requirements for those systems An approach to elicit the sometimes subjective and elusive ... Centre of Finland, VTT Electronics, Finland Maarit Tihinen, VTT Technical Research Centre of Finland, VTT Electronics, Finland Marco Lormans, Delft University of Technology, The Netherlands Rini...

391
300
0

A research proposal submitted in partial fulfillment of the requirements for the degree of Master of Business Administration

Ngày tải lên : 13/04/2013, 10:30

... South Korea, the Philippines; Macro is in Thailand and Taiwan, Carrefour from France is in Taiwan; and Wellcome is in Taiwan, Hong Kong, Mainland China and Singapore Major Japanese department stores ... conditioning, convenient and visible washrooms, layout, aisle placement and width, carpeting and architecture have been found to be factors in and of themselves in store image and choice 2.6 Patronage ... assistance during my study period in HCM city and in Bangkok Last but not least, I would like to thank all the faculty and friends at SOM and AIT for their help and boundless inspiration ii Abstract...

51
1K
3

BUILDING CODE REQUIREMENTS FOR STRUCTURAL CONCRETE (ACI 318-99) AND COMMENTARY

Ngày tải lên : 03/08/2013, 11:24

... quality, mixing, and placing; formwork; embedded pipes; and construction joints; reinforcement details; analysis and design; strength and serviceability; flexural and axial loads; shear and torsion; ... industry products, and procedures for design and analysis of precast and prestressed elements and structures composed of these elements Provides design aids and examples.) “Design and Typical Details ... and wire size and weight tables Lists specifications and properties and manufacturing limitations Book has latest code requirements as code affects welded wire Also gives development length and...

1.3K
1.8K
16

Requirements for the Generic Bus Driver Model

Ngày tải lên : 07/10/2013, 00:20

... configuration changes and can easily handle hot swapping of devices • Interoperability of devices on the bus is promoted because functions on the bus can come from multiple IHVs and generic extensions ... ranges, power, and/ or bandwidth, can the function use? What driver(s) can control the device? • Loads a driver for each function it discovers • Gives each function a unique structure or handle (provides ... for these buses must understand what the generic bus driver model means for a device on that bus and strive to design devices that are discoverable, self-describing, and multiplexable Send feedback...

6
326
0

Requirements for entry

Ngày tải lên : 01/11/2013, 09:20

... Chemistry and two from Biology, Mathematics and Physics Chemistry and two from Mathematics, Physics and Biology or Human Biology Acceptable on its own and combined with other qualifications Chemistry and ... good for her and for her hospital Then there is the invaluable down-to-earth ability to organise and to cope; a capable pair of hands and a reassuring attitude of “leave it to me and I’ll sort ... and wellbeing to his doctor Thus, the character and personality of the doctor, his sympathy and understanding, his sense of responsibility, his selflessness are as important as his scientific and...

22
270
0

IEEE Recommended Practice for Software Requirements SpeciÞcations

Ngày tải lên : 21/11/2013, 23:46

... IEEE Standards documents are developed within the IEEE Societies and the Standards Coordinating Committees of the IEEE Standards Association (IEEE-SA) Standards Board Members of ... between the system and its software portion, and will place external performance and functionality requirements upon the software portion Of course the SRS should then agree with and expand upon these ... specify the responses to both valid and invalid input values Full labels and references to all Þgures, tables, and diagrams in the SRS and deÞnition of all terms and units of measure 4.3.3.1 Use...

37
597
0

Tài liệu Cabling Standard - TIA 607 - Commercial Building Grounding and Bonding Requirements for Telecommu doc

Ngày tải lên : 10/12/2013, 02:15

... OVERVIEW OF THE TELECOMMUNICATIONS GROUNDING AND BONDING INFRASTRUCTURE The electrical service entrance is outside the scope of this Standard and is grounded and bonded in accordance with all applicable ... bonding and grounding for telecommunications shall be met The telecommunications grounding and bonding infrastructure begins with a connection to the service equipment (power) ground and extends ... protected from physical and mechanical damage should be installed without splices, where practicable If splices are required, they: • • • should be minimum and shall be accessible and located in telecommunications...

7
593
2

Tài liệu Module 3: Using a Conceptual Design for Data Requirements docx

Ngày tải lên : 10/12/2013, 17:15

... Conduct interviews with users, managers, and other customers • Shadow users, managers, and other customers to gain first-hand knowledge of the skills and experience necessary to perform a task ... functional requirements, and nonfunctional requirements " Identifying sources from which to obtain relevant and supporting information Sources can include people, systems, and systems-support documents ... process of investigation This process involves gathering and analyzing data from users, systems, and documentation to determine the current state and desired future state of the solution Gathering...

20
580
0

iec 60269-2-1 low-voltage fuses - supplemetary requirements for fuses for use by authorized perso

Ngày tải lên : 25/12/2013, 10:47

... TTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTT Be \DP037G5@h&(i 5and5 ,h&(i TTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTT ... TTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTT @>d \DP037G5@h&&&i 5and5 ,h&&&i TTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTT...

264
753
4

iec 60269-2 low-voltage fuses - supplementary requirements for fuses for use by authorized person

Ngày tải lên : 25/12/2013, 10:53

... standard limits for time-current characteristics based on reference ambient air temperature of 20 Y are given in Table A and Figure 1, ! page 14 The standardized k-factors are: ko = 1.5, k, = and ... B and in the note, the value "660 V" by "690 V" Page 11 7.7 I2t characteristics Add the following text at the end of the subclause: For "gD" and "gN" fuse-links, the limits of pre-arcing I2t and ... Graphical and letter symbols Pour les symboles graphiques, symboles littộraux et signes dusage gộnộrai approuvộs par ia C E I , le lecteur consultera: For graphical symbols, and letter symbols and...

30
315
3

iec 60269-4-1 low-voltage fuses - supplementary requirements for fuse-links for the protection of

Ngày tải lên : 25/12/2013, 10:54

... `,,`,`,``,````,,,,,`,````,```-`-`,,`,,`,`,,` - Standards Survey Q1 Please report on ONE STANDARD and ONE STANDARD ONLY Enter the exact number of the standard: (e.g 60601-1-1) Q6 standard is out of date standard is incomplete standard ... International Standards transparently to the maximum extent possible in their national and regional standards Any divergence between the IEC Standard and the corresponding national or regional standard ... of types of standardized fuse-links Explanatory note – In view of the fact that this standard should be read together with IEC 60269-1 and 60269-4, the numbering of its clauses and subclauses...

42
420
2

iec 60269-4 low-voltage fuses - supplementary requirements for fuse-links for the protection of s

Ngày tải lên : 25/12/2013, 10:55

... times and currents Replace the existing text by the following: 5.6.2.1 Conventional times and currents for aR fuse-links Not applicable 5.6.2.2 Conventional times and currents for g R and gS ... capability For d.c.: 8.5 No 13 gR and gS breaking capacity and operating characteristics No 12a aR breaking capacity and operating characteristics No 12 Breaking capacity and operating characteristics ... publications are quoted in this standard: 147-0 (1966): Essential Ratings and Characteristics of Semiconductor Devices and General Principles of Measuring Methods, Part O: General and Terminology 269-1 (1968):...

87
404
1

iec 60364-7-707 electrical installations of buildings - requirements for special installations or

Ngày tải lên : 25/12/2013, 11:05

... 2003; International Electrotechnical Commission Plugs and Socket-outlets for Domestic and Similar General Use Standards Plugs, Socket-outlets and Couplers for Industrial Purposes Part : General ... Equipment, for equipment connected via a plug and socket complying with I E C Publication 83 : Plugs and Socket-outlets for Domestic and Similar General Use Standards, or similar: - complies with those ... conductor of not less than 2.5 mm2 shall be used d) Rigid and flexible metallic conduits, metallic trunking and ducting and metallic screens and armouring which meet the requirements of Sub-clause...

23
295
4

iec 60439-2 low-voltage switchgear and controlgear assemblies - particular requirements for busba

Ngày tải lên : 25/12/2013, 11:05

... International Standards transparently to the maximum extent possible in their national and regional standards Any divergence between the IEC Standard and the corresponding national or regional standard ... Low-voltage switchgear and controlgear assemblies, of IEC technical committee 17: Switchgear and controlgear This third edition cancels and replaces the second edition published in 1987 and its amendment ... (busways) General 1.1 Scope and object Add the following paragraphs: This International Standard applies to busbar trunking systems (BTS) and their accessories for feeding and distributing electrical...

74
820
14

iec 60439-3 low-voltage switchgear and controlgear assemblies - particular requirements for iow-v

Ngày tải lên : 25/12/2013, 11:06

... International Standards transparently to the maximum extent possible in their national and regional standards Any divergence between the IEC Standard and the corresponding national or regional standard ... 1211 GENEVA 20 Switzerland i(I COPYRIGHT International Electrotechnical Commission I Licensed by Information Handling Services Q1 Please report on ONE STANDARD and ONE STANDARD ONLY Enter the ... STANDARD ONLY Enter the exact number of the standard: (e.g 60607-1-1) Q6 standard is out of date standard is incomplete standard is too academic standard is too superficial title is misleading...

49
488
4

iec 60439-4 low-voltage switchgear and controlgear assemblies - particular requirements for assem

Ngày tải lên : 25/12/2013, 11:07

... International Standards transparently to the maximum extent possible in their national and regional standards Any divergence between the I EC Standard and the corresponding national or regional standard ... and regulating equipment complete with all their internal electrical and mechanical connections and structural parts (see 2.4), designed and built for use on all construction sites, indoors and ... be connected to the ACS 7.2.5 Lifting and handling devices of ACS Lifting rings and/ or handles (or any other equivalent system) shall be provided on the ACS and be firmly attached to the enclosure...

56
514
5

iec 60439-5 low-voltage switchgear and controlgear assemblies - particular requirements for assem

Ngày tải lên : 25/12/2013, 11:08

56
776
6