...
Cisco Certified Network Associate 3. 0
CCNA 3. 0
Version 1
640-607
www.testking.com
-20-
1 – means the file is not compressed and can be moved.
120 -3 – represents the version number ... IEEE 802 .3 – this operates at 10 Mbps over coaxial cable,
UTP and fiber.
2. 100 Mbps Ethernet (IEEE 802.3u) – this is also known as the Fast Ethernet that
operates over UTP or fiber.
3. 1000 ...
128 + 64 + 1 = 1 93
Using the same table to translate the other three octets would give us the following result.
00001010 = 8 + 2 = 10
00011110 = 16 + 8 + 4 + 2 = 30
00000010 = 2
So...
... service. See
Chapter 3 for more information.
32 .
D. The command used to copy a configuration from a router to a
TFTP host is copy flash tftp. See Chapter 7 for more information.
33 .
E. The clock ... Chapter 3
for more information.
Copyright â2002 SYBEX, Inc., Alameda, CA
www.sybex.com
lxii Answers to Assessment Test
52.
B. The Cisco command Novell-ether is the encapsulation for 802 .3.
However, ... runn
59.
If you connect a Cisco router and a 3Com router through a T-1, why
won’t they work by default?
A.
Cisco and 3Com are not compatible.
B.
3Com was purchased by Cisco and scrapped.
C.
The...
... (Cisco Press: 2000) pages 29 – 30 .
640-607 33
21certify.com
640-607 42
21certify.com
s0/0 .39 point-to-pointRouter(config-if)#frame-relay interface-dlci 139 Router(config-
if)#exitRouter(config)#exitRouter#copy ... subnets?
Answer: 255.255.255.248 Explanation: We need 3 bits for the hosts (2 ^3- 2=6 > 5). This would
provide for 30 subnets (2^5-2 =30 ). A 29bit (24 + 5) network mask translates the 4
th
...
Q .35 Which channels are used by ISDN BRI?
A. 2d+b
B. 23d+b
C. 2b+d
D. 23b+d
Answer: C Explanation: ISDN BRI has two Bearer Channels (B) and a Signaling channel (D).
Reference: Cisco CCNA...
... mode before seting duplex mode.
www.ipmac.com.vn
CCNALAB No. 3 : LAN Switching Lab time: 1 session
Students are recommended to read the entire lab requirement before starting. The TIP session ... the flash of your switch to recover it in case
of corruption.
End of LAB No3
www.ipmac.com.vn
2 Vlan 2 Fa0/2
3 Vlan 3 Fa0 /3
4 Vlan 4 Fa0/4
The command vlan database can be used in the Privileged ... use another Switch
as 35 50 series you need to verify encapsulation type via command :
Switch_A(config-if)# switchport trunk encapsulation <encapsulation type>
3. Because of security purpose,...