... FrameNet consists of a set of layers One of the layers defines the target, and the other layers provide additional information with respect to the target The following layers are used: • The FE layer, ... like to study how the information provided by the additional layers influence the performance of the traditional task for a semantic parser FE identification, especially for noun and adjective target ... part-of-speech-specific layer, which contains aspectual information for verbs; and copulas, support expressions, and slot filling information for nouns and adjectives • Class membership: John is a...
... (DR) At a wavelength of 600 nm, for neat TiO2 nanotube structures only a 3% change could be obtained whereas for the WO3 loaded systems 45% for the as-formed, and 21% for the annealed structure can ... The response time for the as-formed WO3/TiNT is 3.6 s and 2.8 s for the coloration and the bleaching, respectively, while for annealed WO3/TiNT the values are 11.4 s and 10.1 s for coloration and ... line with literature reports for pure WO3 [16] Furthermore, the onset potential for the cathodic reaction for WO3/TiNT (with amorphous WO3) is located at $0.3 V while for annealed WO3/TiNT (crystalline...
... bridge-containing region 16–22 of analogues 1, and 3, respectively, and also a linear control peptide for 1a, analogue 1b Conformational analyses by CD: studies of hCt and the analogues in aqueous buffer, ... two type I b turn conformeric forms that have been described by Perczel et al [43] Importantly, the 50% TFE solvent system allowed for a clear distinction between the conformation of 1a vs 1b ... indicated Data for 1–6 represent the mean ± SD for three to five independent experiments and data for hCt and sCt are the mean of 13 and 14, respectively, assays Ó FEBS 2002 Conformationally constrained...
... (NH3/H2O2/H2O = 1:1:5, v:v) at 75°C for h in turn, to obtain a hydrophilic surface The Si substrates were then rinsed in deionized water for several times For their application in solar cells, ... *10% for the long wavelengths 700 nm and high reflection loss [ 20% for shorter wavelengths 400 nm, lower than that of individual Si3N4 or MgF2 SLARC [27] In our case, the reflection loss for PASiNP ... to *5.8% within the wavelength range of 400–1,000 nm and therefore can replace other surfacetextured microstructures [20, 24–26] For the other ARCs, the Si3N4/MgF2 DLARC shows the low reflection...
... and P3HT + SMU Page of PCBM were formed on the ITO-coated glass by spin-coating The spin speed of the polymer film was 4,000 rpm for PEDOT:PSS and 1,000 rpm for P3HT + PCBM Then, ECHD and Al ... therefore, the minimum F value was found for the ECHD (0.7 nm)/Al structure In this structure, the F value was decreased to 3.62 eV from the F of Al, which is 4.12 eV A possible reason for this ... atomic force microscopy [AFM] (ThermoMicroscopes Corporation, Sunnyvale, CA, USA) Spectra were recorded on AXIS NOVA (Kratos Inc., Chestnut Ridge, NY, USA) using a He I (21.22 eV) source for ultraviolet...
... height, given by c = (P · 3) + t, where P stands for the bitplane number, and t stands for the coding pass type with t = {2 for SPP, for MRP, for CP} Coding passes are encoded from the highest ... equal-size layers 3.5 20 log-size layers Scale Figure 3: Coding performance evaluation between SCALE and two common allocation strategies distributing quality layers logarithmically and uniformly ... equal-size layers 3.5 40 log-size layers Scale Figure 4: Coding performance evaluation between SCALE and two common allocation strategies distributing quality layers logarithmically and uniformly...
... solutions for a discrete plankton model Naturally, more realistic models require the inclusion of the periodic changing of environment (e.g., seasonal effects of weather, food supplies, etc) For such ... vector space, respectively 4 Periodic solutions for a discrete plankton model Suppose {g(k)} is an ω-periodic (ω ∈ Z + ) sequence of real numbers defined for k ∈ Z Throughout this paper, we will use ... obtain 2 β12 + m − 4α12 γ12 − n > β12 − 4α12 γ12 > (3.45) 10 Periodic solutions for a discrete plankton model Therefore, the equation α12 x2 − β12 + m x + γ12 − n = (3.46) has two positive solutions...
... latin squares, we provide references for any non-trivial results that we employ For standard references on latin squares consult D´nes and Keedwell [7, 9] and for loops Bruck [2] and Pflugfelder ... observation sets the context for our main results It is well-known in the group case and follows in the loop case for the same simple reasons We include it as part of Lemma 3.1 for completeness Observation ... (Q/N)k for any selection of N ∈ P (Q/N) for i k Having selected each element of Q as a coset representative precisely once, the left-hand side falls in P (Q) and we are done Theorem 2.6 For x...
... censored (event = 0) For the statistical analysis, 6,276 records were used for line W1; 6,916 for line WB; and 3,588 for line WF Data analysis Data were analysed separately for each line Two methods ... 45 days for line W1 and 58 days for line WB) For line WF, the difference in survival days depends on the method used For 2STEP, the difference was largest when CBV was used, whereas for LAM the ... and approximately the same for both methods For line W1 (0.149 vs 0.144) and WB (0.174 vs 0.170), they were slightly, but not significantly, better for 2STEP, whereas for line WF (0.039 vs 0.042)...
... in water distribution affected the mean performance much more severely for line L2 than for line L1, and more severely for both selected lines than for the control line The selection response ... transformed scale, respectively The cumulative selection response (CSR) for line L2 increased faster than for line L1 until generation 11, by contrast, the CSR for line L1 increased faster than for ... error, a power transformation was used [11] The transformation form is as follows: xt t ì y(t1) = log(x) gt (x) = if t = if t = where y is the geometric mean of the ys This transformation relies...
... 18 2.8 Interfacial layers 22 2.8.1 Mechanisms for charge selectivity of interfacial layers 22 2.8.2 Important prerequisites for interfacial layers 24 2.8.3 Poly(3,4-ethylenedioxythiophene):poly(styrenesulfonate) ... MoOx interfacial layers annealed in air and N2 at 180oC for 30min and b) closer view of UPS measurements for the MoOx interfacial layers that reveals emissions from gap states for the sample annealed ... between adjoining layers and (4) act as optical spacers [14, 15] 2.8.1 Mechanisms for charge selectivity of interfacial layers Various mechanisms for charge selectivity of interfacial layers have been...
... Peter HO for including me as a member of the Organic Nano Device Laboratory (ONDL) at which the work described in this thesis is performed I thank Peter for his constant guidance and for his ideas ... structure[41] forms the basis for understanding and improving the performance of organic electronic devices A proper choice of materials can provide a low resistance ohmic contact However for a lot ... structural forms have different energy levels, the benzenoid form being the more stable form The oxidation of the polymer chain involves the abstraction of an electron which results in the formation...
... exception of peculiar cases Main characters of brachyuran zoea used for the identification are represented in Figure RESULTS Key for the identification of brachyuran zoea I (interspecific distinctions) ... Chionoecetes opilio (Figure 11A) Fig Main characters used for the identification of brachyuran zoea key for brachyuran larvae Fig Telson of zoea in Chionoecetes opilio (A), Telmessus ... (1996) A key and bibliography for the identification of zoeal stages of brachyuran crabs (Crustacea, Decapoda, Brachyura) from the Atlantic coast of Europe Journal of Plankton Research 18, 17–27...
... support highspeed data for multimedia services has been the driving forces for developments in third generation, or 3G, infrastructures Perhaps a more subtle reason for the need for 3G is the growing ... may be different for different users within the cell and between cells It is used for transmitting the forward access channel (FACH) for access grant and the paging channel (PCH) for paging, both ... diversity, the BER performance improved as the chip rate increased For a chip rate of 0.96 Mcps, the BER performance was close to the computer simulated BER performance with L=1 The performance with...