... applied to several cases in heatandmass transfer: a) unsteady external flows past a porous square or trapezoidal cylinder, b) natural convective heat- transfer in a porous wavy cavity, c) forced ... (Neale and Nader, 1974; Vafai and Thiyagaraja, 1987; OchoaTapia and Whitaker, 1997; Jang and Chen, 1992; Kim and Choi, 1996; Kuznetsov, 1999) However, other types of interfacial conditions are also ... flow, heatandmasstransfer in porous/fluid coupled domains, and to investigate their effects on local and global heatandmass transfer; To implement the numerical method for unsteady flow past...
... = ln πab a1 b1 +a + a2 + b2 √ a b b1 arctan √ + b a1 arctan √ a1 b1 (1.4) a arctan a − b arctan b where a= asp , L a= a1 = + a2 , bsp , L b1 = + b2 where, asp and bsp are the length and width ... Hirsekorn [Hirsekorn, 1971], Hayakawa et al [Hayakawa and Hwang, 1981], Zanoni [Zanoni and Peri, 1993] and many others The models proposed are based on individual assumptions and though they succeeded ... of a set of algebraic inequalities which are explained in section 1.4 Therefore V and W in these two equations are ”adjusted” water and vapor rather than the actual water and vapor content at a...
... advantages In fact, it is comparatively a cheap and practical facility for biomass gasification [6], and it is also known for the production of syngas with low tar content Banapurmath and Tewari ... experimental and modeling work was conducted by Janajreh and Al Shrah [18] on a small scale batch type downdraft gasifier A near steady state was observed to appear after approximately 15 of operating ... dimensional numerical model to simulate the gasification of a biochar packed bed in dynamic and steady states The model is based on massand energy balances and the chemical kinetics with an exponential...
... Simulation of MassandHeatTransfer in High Moisture Foods, Trans ASAE, pp 55-59 224 Husain A. , Chen C.S., Clayton J T (1973), Simultaneuos HeatandMass Diffusion in Biological Material, Trans ASAE, ... 131-133 Haghighi K., Segerlind L.J, (1988), Modeling Simultaneous HeatandMassTransfer in Isotropic Sphere, Trans ASEA, pp 31 Husain A. , Chen C.S., Clayton J T, Whitney L.F (1972), Mathematical Simulation ... Biological Material, Trans ASAE, pp 69-73 Luikov, A V (1980), Heatandmass transfer, Mir Publisher, Moscow Peebles E D, Christopher D McDaniel (2004), A Practical Manual for Understanding the Shell Structure...
... Publication data Ghiaasiaan, Seyed Mostafa, 1953– Convective heatandmasstransfer / Mostafa Ghiaasiaan p cm Includes bibliographical references and index ISBN 978-1-107-00350-7 (hardback) Heat ... Low-Velocity Laminar Flow Parallel to a Flat Plate 3.3 HeatTransfer During Laminar Parallel Flow Over a Flat Plate With Viscous Dissipation 3.4 Hydrodynamics of Laminar Flow Past a Wedge 3.5 HeatTransfer ... Natural Convection Caused by the Combined Thermal andMass Diffusion Effects 10.15.1 Conservation Equations and Scaling Analysis 10.15.2 HeatandMassTransfer Analogy 10.16 Solutions for Natural...
... Two-Phase Flow andHeatTransfer in Micro-Channels and Their Applications in Micro-System Cooling Yuan Wang, Khellil Sefiane, Souad Harmand and Rachid Bennacer 47 Numerical Methods ... A V Gorin 139 HeatandMassTransfer in Porous Materials with Complex Geometry: Fundamentals and Applications A G B de Lima, S R Farias Neto and W P Silva 161 v vi ... Evaluation of Hygroscopic Inertia and Its Importance to the Hygrothermal Performance of Buildings Nuno M M Ramos and Vasco Peixoto de Freitas Abstract Heating and ventilating are fundamental actions...
... different modes of heatandmass transfer, and learns at an early stage how to solve practical problems and to design heatandmasstransfer apparatus This increases the motivation to study the ... theory of heatandmasstransfer Such problems are dealt with in the first chapter, which contains the basic concepts and fundamental laws of heatandmasstransfer The student obtains an overview ... main applications An introduction to gas radiation, important technically for combustion chambers and furnaces, is the final part of this chapter As heatandmasstransfer is a subject taught at...
... between heat flux andheat rate *This icon identifies examples that are available in tutorial form in the Interactive HeatTransfer (IHT) software that accompanies the text Each tutorial is brief and ... and/ or exploratory, whatif, and parameter sensitivity considerations be addressed using a computational equationsolving package To this end, the Interactive HeatTransfer (IHT) package available ... bright, andheattransfer is a topic that is crucial to address a broad array of technological and environmental challenges In preparing this edition, we have sought to incorporate recent heat transfer...
... a h2 dA Aand since F ¼ rg sin a hA, we have hc:p: ¼ Ah Z h2 dA ¼ A Iaa Ah (2-5) The moment of the area about the surface may be translated from an axis aa located at the fluid surface to an axis ... Fundamental Considerations in Convective MassTransfer 517 Significant Parameters in Convective MassTransfer 519 Dimensional Analysis of Convective MassTransfer 521 Exact Analysis of the Laminar ... Fundamentals of Momentum, Heat, andMassTransfer 5th Edition Fundamentals of Momentum, Heat, andMassTransfer 5th Edition James R Welty Department of Mechanical Engineering Charles E Wicks Department...
... insulated from dryer wall, (3) Heater and switch are isothermal at Tset, (4) Negligible heattransferfrom sides of heater or switch, (5) Switch surface, As, loses heat only by convection ANALYSIS: ... coefficients in air and water at a prescribed temperature FIND: Heater surface temperatures in water and air SCHEMATIC: ASSUMPTIONS: (1) Steady-state conditions, (2) All of the electrical power is transferred ... variations for 0.2 and 0.3 SCHEMATIC: ASSUMPTIONS: (1) Uniform surface temperature, (2) Chamber walls are large compared to the spherical package, and (3) Steady-state conditions ANALYSIS: From...
... provide a foundation in basic momentum, heat, andmass transfer/ transport sufficient to permit the student to elementary design and analysis, and adequate as a base from which to learn more advanced ... Single-phase heattransfer coefficients Figure 7.3.2- Single-phaseheat transfer coefficients Correlationsfor prediction of heattransfer Average heattransfer coefficients Example 7.3.2-I Average heat ... mass balance Accumulation of mass Input and output of mass Simplified forms of the macroscopic total mass balance Example 2.1.1-1 Mass balance on a surge tank Figure 2.1.1- Surge tank Example...
... is called the heat capacity of the system The basic analysis in heattransfer always has to start with one of these relations Chapter 1 FUNDAMENTALS OF HEATANDMASSTRANSFER The second law of ... are the resistances in series calculated based on the reas A1 , A2 , A3 etc 1.3.2 Energy Balance With Heat Transfer: There are situations when a body receives heat by convectionand radiation and ... FUNDAMENTALS OF HEATANDMASSTRANSFER Solution: In the absence of atmosphere the only possible way heat is dissipated is by radiation The temperature of the space may taken as 0K Hence heat generated...
... constant phase element and resistance, related to the charge transfer processes (kinetic), and another parallel mini-circuit constant phase element and resistance, associated to mass transfer, ... charge Charge transfertransfer resistance resistance (Rct) Cathode Masstransfer polarization resistance (Rmt) ANODE CHARGE TRANSFER CONTRIBUTION (a) CONTRIBUTION (RΩ) CATHODE MASSTRANSFER CONTRIBUTION ... in an effective water management, and provides a pathway for the access of the reactant gases when massive amounts of water are being generated in the cathode (Park et al., 2004) Also, this amount...
... simultaneous heatandmasstransfer on the cooling surface Many experimental, and few numerical, studies have been carried out to study the heatandmasstransfer characteristics of the fin -and- tube ... the mass balance equation for water vapor (Eq 25), the energy balance equation for air stream (Eq 30), the heattransfer equation in the fin surface (Eq 41) and the heatandmasstransfer equations ... Ta, Wa Moist air Tc Outlet Ta,o Wa,o m "a, dry WS,c(Tc) Condensate-film Cold wall Tw Fig Air dehumidification by a cold wall Numerical Analysis of HeatandMassTransfer in a Fin -and- Tube Air Heat...
... calculation algorithm for heatandmasstransfer models 54 HeatandMassTransfer – Modeling and Simulation 2.5 Heat performance characterization In order to evaluate the fin thermal characteristics, we ... exchanger Ones the airflow profile was determined, the water vapor, air stream and fin heatandmass balance equations were solved simultaneously It Numerical Analysis of HeatandMassTransfer ... Numerical Analysis of HeatandMassTransfer in a Fin -and- Tube Air Heat Exchanger under Full and Partial Dehumidification Conditions 61 curves are plotted As the condensation factor C and the...
... possible reason may be that heatandmasstransfer is fast on the CuO/ZnO/Al2O3 catalytic coating than the conventional fixed bed catalyst, especially in micro-reactors 78 HeatandMassTransfer ... was used as a driving gas and carrying gas with an inlet pressure of 1.4 and 1.6 MPa for the heating gas and powder carrying gas separately Heating gas temperature range is 573 K to 773 K Stand-off ... for heat exchange; outside surface of the unit is adiabatic; gravity of the gases and the radiation heattransfer was also neglected Kinetic model adopted was the DE and SR parallel mechanism as...
... fraction leads to a degradation in the heat Fig 10 Heattransfer coefficient at wall for CuO / water nanofluid HeatandMassTransfer in External Boundary Layer Flows Using Nanofluids 107 transfer ... natural and forced convective heatandmasstransfer regimes for nanofluids flowing in semi-infinite geometries, i.e external boundary layer flows along 96 HeatandMassTransfer Modeling and ... 0378-7753 HeatandMassTransfer in External Boundary Layer Flows Using Nanofluids Catalin Popa, Guillaume Polidori, Ahlem Arfaoui and Stộphane Fohanno Universitộ de Reims Champagne-Ardenne, GRESPI/Thermomộcanique...
... volume fraction, for both nanofluids, traducing both heatandmasstransfer in forced convection It clearly appears that the thermal flow rate is strongly dependent 113 HeatandMassTransfer ... (2003) Buoyancy-driven heattransfer enhancement in a two-dimensional enclosure using nanofluids Int J HeatMass Transf Vol 46 pp.3639-3653 Heat andMassTransfer in External Boundary Layer Flows ... 126 HeatandMassTransfer – Modeling and Simulation where Afr is the packing area, L fi is the height of packing, c1 and c5 are constants that depend on the type of fill, and mw,m is the average...
... material will attain if dried for an infinite time at a particular relative air humidity and temperature The relation 150 HeatandMassTransfer – Modeling and Simulation between the material moisture ... mathematical models It is highly 144 HeatandMassTransfer – Modeling and Simulation dependent on the completeness of the mathematical model and the relationships used to describe heatandmasstransfer ... the capital cost For all cases analyzed here the minimum possible area was obtained, which means that the packing area is a major variable affecting the total annual cost The cooling capacity...