... stresses TheAlternateDesignMethod was intended to give results that were slightly more conservative than designs bythe Strength DesignMethodofthe Code TheAlternateDesignMethodofthe 1999 ... supervision of a licensed design professional or by a qualified inspector R1.3.1 — Inspection of construction by or under the supervision ofthe licensed design professional responsible for thedesign ... honeycombing Note that the limitations on maximum size ofthe aggregate may be waived if, in the judgment ofthe licensed design professional, the workability and methods of consolidation ofthe concrete...
... was not used in the training and selected for the evaluation ofthe model We used the speech of four people for the evaluation The evaluation results are shown in Table They are the accuracy (detection ... letting us use the pictures (Figure 3, 4) of their news program for the purpose of our research References Figure Captions in the picture Figure Captions outside ofthe picture Most ofthe subjects ... there are too many of them to be understood well (Komine et al 1996) Therefore we need to summarise the news texts to some extent, and then show them on the screen The aim ofthe research on automatic...
... SW3560_01(config)#interface range gigabitEthernet 0/1 - SW3560_01(config-if-range)#switchport trunk encapsulation dot1q 1 68 Giáo trình thực hành BCMSN Chương – Planning for Implementation of Voice in a Campus SW3560_01(config-if-range)#switchport ... 161 Giáo trình thực hành BCMSN Chương – Planning for Implementation of Voice in a Campus Hình 7.1.3-1: Show interface fastEthernet 0/15 switchport SW2950_02 Bước 6: Xóa cấu hình, khởi động lại ... SW3560_01(config)#interface range gigabitEthernet 0/1 - SW3560_01(config-if-range)#switchport trunk encapsulation dot1q 164 Giáo trình thực hành BCMSN Chương – Planning for Implementation of Voice in a Campus SW3560_01(config-if-range)#switchport...
... taken ofthe relative reliability ofthe pile test data (using a carefully designed weighting procedure), the methods listed below for each category of pile lead to the lowest probability of failure: ... approaches that of a closedended pile with the same outer diameter The displacement induced in the sand in the vicinity ofthe base is most conveniently expressed in the terms ofthe effective ... using the mean IFR value measured over the final 3D of pile penetration while the value of Ars* was assessed from the mean IFR value recorded over the final 20D of penetration In the absence of...
... behavior of piles is influenced profoundly bythemethod used to install the piles and cannot be predicted solely from the physical properties ofthe piles and the undisturbed soil Furthermore, the ... improve the accuracy ofthedesignof single axially load pile by using FEM In a nutshell, it tackles the prediction by developing a numerical model that includes the effects of installation method, ... Evaluation ofthe MC and the HS model 81 3.4.2 Evaluation ofthe HYP model 84 3.5 APPLICATIONS 85 3.5.1 Strain softening behavior of pile-soil interface 85 3.5.2...
... divider panel is used, then bond cable tray to main panel • A divider panel is used on the right to segregate very-dirty wiring from the clean zone ofthe next panel to the right • The divider panel ... structure and thepanel (Ve) and between thepanel and drive chassis (Vf) The circuit of an encoder mounted on the motor will then have a voltage spike of amplitude Vd + Ve relative to thepanel and ... normally outside the control ofthe system designer so that it is necessary to concentrate on the transmission of noise between them Coupling Mechanisms The coupling mechanism is the means by which electrical...
... 3-D model ofthe spring Fig 2b presents a 2-D view ofthe spring Table shows the dimensions ofthe spring The proposed spring is designed by combining between the rigid links with the in -of- plane ... Shape modes ofthe compliant planar spring Table The natural frequencies of proposed spring Mode shapes Frequency (Hz) 1st 64.717 2nd 166. 78 3rd 282 . 08 4th 4 28 .14 5th 680 .85 6th 80 4.47 AN APPLICATION ... where c is the damping coefficient ofthe damper The dynamic equation ofthe proposed isolator is derived by combining Eqs (2) and (3) The Lagrange L is formed by taking the difference ofthe scalar...
... lost sight of them in the gloom into the - The tram rattled off into the gloom out ofthe - Two figures materialized out ofthe gloom through the - She could see the house faintly through the gloom ... Weparked on the grass verge bythe side ofthe road • PREP across the - They all set off across the grass in the - I found the wallet lying in the grass on the - You're not allowed to walk on the grass ... I be bathed in The whole village was bathed in the glow ofthe setting sun • GLOW + VERB light sth Our faces were lit bythe faint green glow ofthe dashboard lights • PREP -from the soft glouifrom...
... forcing the warm air to rise The gravitational pull ofthe earth on all objects holds them to the surface ofthe earth Without it, the spin ofthe earth would send them floating off into space The ... because they developed a method for measuring the amounts of different substances independently of their volumes 12 The density of a mixture of two liquids usually depends on the ratio in which they ... of gravitation, equal to the gravitational force between any two particles times the square ofthe distance between them, divided bythe product of their masses Hằng số hấp dẫn Gravity (n): the...
... lost sight of them in the gloom into the - The tram rattled off into the gloom out ofthe - Two figures materialized out ofthe gloom through the - She could see the house faintly through the gloom ... Weparked on the grass verge bythe side ofthe road • PREP across the - They all set off across the grass in the - I found the wallet lying in the grass on the - You're not allowed to walk on the grass ... I be bathed in The whole village was bathed in the glow ofthe setting sun • GLOW + VERB light sth Our faces were lit bythe faint green glow ofthe dashboard lights • PREP -from the soft glouifrom...
... Introduction The requirements of Part supplement, modify or replace the general requirements ofthe other parts of I E C Publication 364 The numbers following the particular number of section of Part ... requirements of I E C Publication 435 which cover leakage current The requirements of this section apply to the installation up to the point of connection ofthe equipment (see Figure Al, page 17) These ... 543 707.471.3.3.3 Note Use of double wound transformer - The aim of these requirements is to localize the path ofthe leakage current, and minimize the possibility of a break in continuity in...
... Accounts To begin the lab, open Microsoft Internet Explorer and click the name ofthe lab Play the video interviews for students, and then instruct students to begin the lab with their lab partners ... Directory as part ofthe user’s long-term key NTLM Stored as an MD4 hash value ofthe password LAN Manager Stored as the concatenation, or linking, ofthe two 7-character halves ofthe password that ... Media are either registered trademarks or trademarks of Microsoft Corporation in the United States and/or other countries The names of actual companies and products mentioned herein may be the trademarks...
... THE FEDERAL ACCOUNTING STANDARDS ADVISORY BOARD The Federal Accounting Standards Advisory Board (FASAB or the Board”) was established bythe Secretary ofthe Treasury, the Director ofthe Office ... background information is available from the FASAB: • “Memorandum of Understanding among the General Accounting Office, the Department ofthe Treasury, and the Office of Management and Budget, on Federal ... accordance with the existing standard The confusion for the user derives from the difficulty inherent in comparing the financial statements for two or more periods when the effect ofthe error is...
... and Asp87-Thr88Lys89-Gly90) overlap with b-turn regions of rat CD2 (Arg37-Gly 38- Ser39-Thr40 and Ser87-Thr 88- Asn89Gly90) In CD2–CD 58 complex, the residues in the b-turn and flanking residues of this ... (Fig 1) The residues in the b-turn of rat CD2 sequence are Arg37-Gly 38- Ser39-Thr40 and Ser87-Thr88Asn89-Gly90, while those in human CD2 are at Thr38Ser39-Asp40-Lys41 and at Asp87-Thr 88- Lys89-Gly90 ... with CD 58 The flanking residue Tyr86 ofthe b-turn at Asp87-Thr 88- Lys89-Gly90 has been shown to be Ó FEBS 2004 Designof peptides for T-cell adhesion inhibition (Eur J Biochem 271) 288 3 important...
... phosphorylation ofthe MAP kinase activation loop [3 ,14, 18] , Y2H interaction of these MAP kinases with the two isoforms of human Hsp90 was strengthened by heat shock (Fig 5A) The stronger interaction of ERK5 ... Mkk1 ⁄ 2p [3 ,14, 18] We used the yeast two-hybrid (Y2H) system to determine the relative strengths of in vivo interaction of these two MAP kinases with the two isoforms of human Hsp90 In the yeast ... increase the final biomass yields of PP30[pHSP82], relative to the other strains tested (Fig 6) In addition, at high temperature (37 °C as compared to 30 °C), the presence ofthe Hsp82 isoform of yeast...
... before [ 28] Synthesis of 7-DHP The 7-DHP standard was synthesized from pregnenolone acetate following protocols described in [29] The chemical structure ofthe standard had been confirmed by NMR ... (Invitrogen), and the isolation of RNA followed the manufacture’s protocol The synthesis of first-strand cDNA was performed using the Superscript preamplification system (Invitrogen) Either lg of total ... characteristic of 7-DHP (Fig 5) The H-NMR spectrum ofthe biotransformation product is in agreement with that ofthe chemically synthesized standard (Fig 5) and with data from the literature [41] Thus, the...
... minimized by setting the vacuum relief valve at the highest vacuum permitted bythedesignofthe vessel 2.7.1.2 Other considerations for piping design are as follows: a Keep the number of shell ... remote shut-off capabilities to limit the size of vapor clouds 2.6.3 DESIGN PRESSURE Thedesign pressure shall be no less than the vapor pressure ofthe stored product at the maximum design temperature ... For these valves to be effective, the downstream piping must have a ßow capacity greater than thedesign shutoff point ofthe excess ßow valve The main advantages of these valves are that (a) they...
... achieve these principles The results of these tasks will provide us with clear guidelines for aesthetic evaluation of alternative designs as well as for facilitating design for aesthetics 3.1 Aesthetic ... supported design for aesthetics in a number of ways By manipulating the identified design variables in terms of shape, composition and physical properties of a a given designed product, aesthetic ... Pye D., The Nature and Aesthetics ofDesign , The Herbert Press, UK, 1995 Reich, Y., “A Model of Aesthetic Judgment in Design , Artificial Intelligence in Engineering, vol .8, no.2, pp .141 - 153,...