... your Porsche could
cause accidents and severe or fatal personal
injuries.
Note to owners
In Canada, this manual is also available in French.
To obtain a copy contact your dealer or write to: ...
important for safe and fatigue -free driving.
We recommend the following procedure for adjust-
ing the driver’s seat to suit individual
requirements:
1. Vehicles with manual transmission:
Adjust ... dealer, or Porsche Cars
N.A
To contact NHTSA, you may either call the Auto
Safety Hotline toll -free at 1(800)424-9393 (or
366-
0123 in Washington, D.C. area) or write to: NH-
TSA, U.S. Department...
... X05-88988
Released: 9 /2000
Manual Classroom Setup Guide
Released: 9 /2000
Course Number: 2071A
Querying Microsoft
đ
SQL Server
2000 with
Transact-SQL
Manual Classroom Setup ... the Microsoft Windows 2000 Advanced Server compact disc into the
CD-ROM drive.
Note
Note
Im
portant
Manual Classroom Setup Guide 7
To copy the Microsoft SQL Server 2000 installation files ... Manual Classroom Setup Guide 1
Manual Classroom Setup
Use the following instructions to set up the classroom manually. Before you
begin, decide whether...
... refrigeration
system freezes at expansion valve
orifice and temporarily stops cycle,
but normal state is restored after a
time when the ice melts
z Drier oversaturated state
z Moisture in refrigeration system
freezes ... CYLINDER
HINT:
When handling the charging cylinder, always follow the direc-
tions given in the instruction manual.
(a) Charge the proper amount of refrigerant into the charging
cylinder.
(b) Connect the ... CONDITIONING AIR CONDITIONING SYSTEM
2484AuthorĂ: DateĂ:
9. SUPPLEMENTAL RESTRAINT SYSTEM (SRS)
The CAMRY is equipped with an SRS (Supplemental Restraint
System) such as the driver airbag and passenger...
... bolt.
(c) Pry up the pipe with a screwdriver and remove the pipe.
8. REMOVE MANUAL VALVE BODY
Remove the 5 bolts and manual valve body.
9. REMOVE CONNECTOR CLAMP AND PIPE RETAINER
Remove the 2...
... hammer and punch, drive out the pin.
(d) Slide out the shaft and remove the manual valve lever
from the case.
57. REMOVE MANUAL SHAFT OIL SEAL
Remove the oil seal with a screwdriver.
AUTOMATIC ... SUBASSEMBLY
1. REMOVE PARK/NEUTRAL POSITION SWITCH
(a) Remove the manual shift lever.
(b) Pry off the lock washer and remove the manual valve
shaft nut.
(c) Remove the 2 bolts and pull out the ... in.
2.80 mm
0.1103 in.
AUTOMATIC TRANSAXLE SERVICE SPECIFICATIONS–
AX–14
Valve Body Spring
Spring
Free length and Coil outer
diameter mm (in.)
Total No. of coils and Color
Upper valve body
Throttle...
... lock manual switch OFF or UNLOCK No continuity
A16 – Ground Door lock manual switch LOCK Continuity
A17 – Ground Door lock manual switch OFF or LOCK No continuity
A17 – Ground Door lock manual ... No.1)
5. Wire Harness
–
–
–
BE–70
–
Door lock system does not operate by manual switch.
1. Power Window Master Switch
2. Door Lock Manual Switch
3. Integration Relay (I/P J/B No.1)
4. Wire Harness
BE–60
BE–70
BE–70
–
Door ... and verify that the lights
go on when the ignition switch is turned ON.
BE0AF–02
N18026
Free
Pushed in
Free
Pushed in
w/o Cruise control:
w/ Cruise control:
1
2
3
1
2
4
N20208
1
2
–BODY ELECTRICAL...
... disc.
HINT:
If the disc cannot be removed easily, turn the shoe adjuster until
the wheel turns freely.
4. REMOVE SHOE RETURN SPRINGS
Using needle–nose pliers, remove the shoe return springs.
5....
... PEDAL FREEPLAY AND
PUSH ROD PLAY
(a) Loosen the lock nut and turn the push rod until the free-
play and push rod play are correct.
(b) Tighten the lock nut.
(c) After adjusting the pedal freeplay, ... Tighten the lock nut.
3. CHECK THAT PEDAL FREEPLAY AND PUSH ROD
PLAY ARE CORRECT
Push in on the pedal until the beginning of clutch resistance is
felt.
Pedal freeplay: 5.0 – 15.0 mm (0.197 – 0.591 ... bearing.
Q10088
Pedal Height
Adjust Point
Push Rod Play
and Freeplay
Adjust Point
Push Rod Play
Pedal Height
CL035–01
CL0042
Pedal Freeplay
CL0512
25 mm (0.98 in. ) or more
Release
Point
Full...
... system.
z Use Toyota Long life Coolant” or equivalent and
mix it with plan water according to the manufactur-
er’s directions.
z Using of coolant which includes more than 50 %
(freezing protection ... Using of coolant which includes more than 50 %
(freezing protection down to –35°C (–31°F) or 60 %
(freezing protection down to –50°C (–58°F)) of eth-
ylene–glycol is recommended but not more than ... between the ”LOW” and ”FULL” lines, when the engine is cold.
If low, check for leaks and add ’ Toyota Long Life Coolant” or Equivalent up to the ”FULL” line.
2. CHECK ENGINE COOLANT QUALITY
(a)...
... output simultaneously, E2 (sensor ground) may be
open.
D Read freeze frame data using TOYOTA hand–held tester or OBD II scan tool. Because freeze frame
records the engine conditions when the malfunction ... be
open. Perform troubleshooting of DTC P0115 first.
D Read freeze frame data using TOYOTA hand–held tester or OBD II scan tool. Because freeze frame
records the engine conditions when the malfunction ... scan tool or
TOYOTA hand–held tester to Data Link Connector
3 (DLC3) on the vehicle. The OBD II scan tool or
TOYOTA hand–held tester also enables you to
erase the DTCs and check freezed frame...
... malfunctioning.
(f) TOYOTA Hand–Held Tester:
Conclude forced driving of the VSV for the EVAP.
(1) Stop the engine.
(2) Disconnect the TOYOTA hand–held tester from the
DLC3.
(g) If you have no TOYOTA Hand–Held ... the
purge line.
(c) TOYOTA Hand–Held Tester:
Forced driving of the VSV for the EVAP.
(1) Connect a TOYOTA hand–held tester to the DLC3.
(2) Start the engine.
(3) Push the TOYOTA hand–held tester ... in this manual.
B06548
Battery
B06545
B06543
Hose Clipper
Air Drain Hose
–EMISSION CONTROL (5S–FE) EVAPORATIVE EMISSION (EVAP) CONTROL SYSTEM
EC–7
1405AuthorĂ: DateĂ:
(d) If you have no TOYOTA...