Thông tin tài liệu
Soneplex
®
Features:
• Remote connections over X.25 TCP/IP or
RS-232
• Local bantam jack RS-232 access
• Access supervision for intrusive testing
• Drop and insert in both directions
• Industry standard test signal generation
• DS1 remote loopback control
• Monitoring and measurement of signal
• No provisioning or periodic maintenance
required
Remote Test Access Unit
(RTAU)
The Soneplex Remote Test Access Unit (RTAU) module provides a full complement of DS1 test
capabilities to the Soneplex Broadband platform. Test capability can now be deployed directly in
the loop electronics, at a cost well below methods typically deployed such as test heads or
portable test equipment. The Soneplex RTAU allows operators to test from multiple points in the
network, both remote and local, supporting intrusive testing, remote loopback control, test sig-
nal generation and insertion, performance monitoring, measurement, jack access, and more.
ADC’s Soneplex system is the lowest total cost solution to expand local loop business services.
In addition to HDSL, HDSL2, traditional T1 repeater or optical DS2 technologies, Soneplex’s
advanced diagnostic and management functions allow maximum control and visibility through-
out local networks. Focused on flexible, end-to-end solutions, the Soneplex system approach
provides robust, cost-efficient transmission and access over either fiber or copper, using a single
platform.
2
www.adc.com • +1-952-938-8080
05/00 • 4082
Soneplex Remote Test Access Unit (RTAU)
Applications
Operators are faced with growing demand for improved DS1 HiCap service and performance while the
types of managed customer premises equipment (CPE) has grown. Operators require a cost efficient
method to determine whether or not a problem is in the network, while avoiding costly dispatches for
problems that are at the CPE. The Soneplex Broadband system with the RTAU module consolidates test
and equipment costs into one node that provides M13, office bay repeater and test head capability and
the ability to test the full circuit remotely.
Test Access
Today’s methods of testing require expensive test heads, additional wiring, and the units monitored are
passive. Testing of remote equipment requires T1 backhaul and test results are often non-standard. A
remote central office will require additional test heads and test sets located in the central office.
Operations Center
REACT
™
M13
WDCS
ORB
DSX-1
M13 Mux
DS3
SONET
SONET
Test
Head
DS3
Central
Remote
Central Office
Figure 1: Typical LEC T1 Testing
Achieve equipment savings and enhanced operation with the Soneplex RTAU.
• Consolidate M13’s, office repeater bays and DSX-1’s and realize immediate relief from costly test head
equipment.
• Enhance test operation systems visibility with direct connections.
• Realize lower cost and time savings!
Figure 2: Soneplex with RTAU LEC T1 Testing
Operations Center
REACT
™
M13
WDCS
DS3
SONET
SONET
DS3
Central
Remote
Central Office
Soneplex
System
R
T
A
U
3
www.adc.com • +1-952-938-8080
05/00 • 4082
Soneplex Remote Test Access Unit (RTAU)
Applications
Description
Competitive local exchange carriers (CLECs) realize the benefits of remote test access when their equipment
is co-located at an RBOC facility. CLEC’s can bypass barriers to entry by remotely monitoring and testing their
equipment at the central office. This includes identifying where the problem is: the CLEC equipment, the cus-
tomer equipment or the RBOC equipment. Using remote dial-in the RTAU can be utilized for remote test
access with or without expensive test software suites.
Figure 3: CLEC Remote Test of Full T1 Circuit: Central Office, and Remote
Operations Center
REACT
™
Customer Premises
Central Office
Soneplex
System
R
T
A
U
CLEC Collocated Equipment
MDF
ILEC
Facility
HDSL Remote
T1
Fiber
HDSL or
HDSL2
The Soneplex Broadband system with the RTAU supplies enhanced remote and local test access and moni-
toring for any one of the 28 T1 signals within the Soneplex system, whether delivered by copper or fiber.
Using TL1 commands, operations systems operators can remotely monitor and control an extensive array of
high capacity digital services (HDCS) testing as defined by Bellcore for access supervision, in-service signal con-
figuration, test signal generation, loopback control, and monitoring and measurement of the signal.
Hekimian and ADC have worked together to also ensure that the Soneplex Broadband system can be tested
using the Hekimian REACT 2001™ remote network test platform. Soneplex supports TL1 over both X.25 or
TCP/IP.
The RTAU is packaged as a single plug-in module. It replaces the TAU module in the TAU slot of the Soneplex
Broadband chassis and requires the Main Processor Unit (MPU) software Version 5.3 or later or the Shelf
Control Unit (SCU) 3.0 or later. Bantam jacks on the front panel of the RTAU provide local test access.
ADC Telecommunications, Inc., P.O. Box 1101, Minneapolis, Minnesota USA 55440-1101
Specifications published here are current as of the date of publication of this document. Because we are continuously improving our
products, ADC reserves the right to change specifications without prior notice. At any time, you may verify product specifications by
contacting our headquarters office in Minneapolis. ADC Telecommunications, Inc. views its patent portfolio as an important corporate
asset and vigorously enforces its patents. Products or features contained herein may be covered by one or more U.S. or foreign patents.
4082 04/00 Original © 2000 ADC Telecommunications, Inc. All Rights Reserved An Equal Opportunity Employer
Web Site: www.adc.com
From North America, Call Toll Free: 1-800-366-3891 • Outside of North America: +1-952-938-8080 Fax: +1-952-946-3292
For a complete listing of ADC's global sales office locations, please refer to our web site.
Description
Soneplex Remote Test Access Unit
Catalog Number
SPX-RTAU0A1
Ordering Information
Dimensions (H x W x D)
9.5 in x 1 in x 9.9 in
(24 x 2.5 x 25 cm)
Soneplex RTAU
Weight:
Operating Temperature:
Storage Temperature:
Relative Humidity:
Input Voltage Range:
Input Current:
Line Code:
Line Rate:
Power Consumption/
Dissipation:
Termination:
12 oz. (0.34 kg)
-40ºF to 149ºF (-40º to 65ºC)
-40ºF to 158ºF (-40º to 70ºC)
5% to 95%, non-condensing
-42 to -60 VDC, -48 VDC nominal
100 mA at -48 V nominal, 175 mA at -48 V max.
AMI or B8ZS
1.544 Mbs ± 130 ppm max.
8.2 watts, maximum
100 ohms nominal ± 5%
. maintenance
required
Remote Test Access Unit
(RTAU)
The Soneplex Remote Test Access Unit (RTAU) module provides a full complement of DS1 test
capabilities to. 4082
Soneplex Remote Test Access Unit (RTAU)
Applications
Description
Competitive local exchange carriers (CLECs) realize the benefits of remote test access when
Ngày đăng: 17/01/2014, 09:20
Xem thêm: Tài liệu Remote Test Access Unit (RTAU) ppt