1 Purpose of camping on cell is a Can make call b Receive system infomations c Choose PLMN d Others CRH is used for calculate C2 of a.Serving cell b.Neighbour cell c a&b Range of timer T3212: a.6 minutes & 24 hours b.1 minute & 24 hours c.6 minutes & 25.5 hours When change T3212 value, does signalling load increase by LU ? a Yes b No c By case The minimum time for MS to read BCCH information of serving cell is a.5 minutes b 30 seconds c Others When in idle mode , which system information will be transferred in BCCH for MS SIB 1,2,3,4,7,8 C2 is transferred in which SIB a b 1&2 c 1&7 d.7&8 Period for MS to calculate C1 and C2 of serving cell is a.1s b 5s c 30s 10 In idle mode which part of network orders MS to change cell a MS b BTS c BSC d MSC 11 Period for MS to calculate C1 and C2 of neighbour cell is a.1s b 5s c 30s 12 If having unusual high LU at edge LAC, what can we a Decrease CRH b.Increase CRH c Others 13 In idle mode, MS identifies Cell by: a LAI&BCCH b BSIC & BCCH c CI& BCCH d LAC& BCCH 14 In idle mode, MS measures: a Serving cell Rx level b Serving cell C/I c Neighbour cells Rx level d Neighbour cells C/I 15 Which procedure is not used in idle mode a Location Updating b Cell Selection c Handover d Cell Reselection ... can we a Decrease CRH b.Increase CRH c Others 13 In idle mode, MS identifies Cell by: a LAI&BCCH b BSIC & BCCH c CI& BCCH d LAC& BCCH 14 In idle mode, MS measures: a Serving cell Rx level b Serving...10 In idle mode which part of network orders MS to change cell a MS b BTS c BSC d MSC 11 Period for MS to... Serving cell C/I c Neighbour cells Rx level d Neighbour cells C/I 15 Which procedure is not used in idle mode a Location Updating b Cell Selection c Handover d Cell Reselection