Đang tải... (xem toàn văn)
Tài liệu Shop Manual & ETM BCM KIA Cerato 2010
2010 > G 1.6 DOHC > Body Electrical System Language Specifications Item Requirement Remark Rated voltage DC 12V Operating voltage range DC ~ 16V Operating temperature range -30°C ~ +75°C Storage temperature range -40°C ~ +85°C Max humidity in use 95% High voltage resistance 24V Insulation resistance 100Mohm or more (measured with 500V MEGGER) Specify as well as parts that insulation like PCB, moisture-proof COATING is required Dark Current Max 4mA (KEYLESS) Max 3mA (NONKEYLESS) Measure when the state, all output loads are OFF and there are no Input SW(including TX operation) changes, continues 2sec Voltage drop 1.2V or less Output terminals for TAIL LAMP RELAY, POWER WINDOW RELAY, SAFETY POWER WINDOW, BURGLAR ALARM RELAY shall be 2.0V or less Shall activate normally in these range Rated Load System Name Capacity Availability in Power Horn relay DC 12V 200mA(Inductive load) B+ Hazard relay DC 12V 200mA(Inductive load) B+ Key hole illumination lamp DC 12V 1.4W(LAMP) B+ Defogger relay DC 12V 200mA(Inductive load) B+ Deicer relay DC 12V 200mA(Inductive load) B+ Central unlock relay DC 12V 200mA(Inductive load) B+ Central lock relay DC 12V 200mA(Inductive load) B+ Drive door unlock relay DC 12V 200mA(Inductive load) B+ Power window enable relay DC 12V 200mA(Inductive load) B+ Front fog relay DC 12V 200mA(Inductive load) B+ Rear fog relay DC 12V 200mA(Inductive load) B+ Tail lamp relay DC 12V 200mA(Inductive load) B+ Head lamp relay DC 12V 200mA(Inductive load) IG2 Front wiper realy DC 12V 200mA(Inductive load) IG2 Drive seat belt indicator lamp DC 12V 1.2W(LED) IG1 Trunk unlock relay DC 12V 200mA(Inductive load) B+ Key solenoide DC 12V 1A (Inductive load) B+ Atm solenoide DC 12V 200mA (Inductive load) B+ 2010 > G 1.6 DOHC > Body Electrical System Circuit Diagram Language 2010 > G 1.6 DOHC > Body Electrical System Language Description Body control module (A) receives various input switch signals controlling time and alarm functions for wiper control, tail lamp auto cut, auto light control, front fog lamp, rear fog lamp, IGN key hole illumination, buzzer control, seat belt warning, key operated warning, ESCL warning, defogger timer, front deicer timer, power window timer, door lock/unlock control, trunk release control Function Wiper Control Wiper Data Flow Washer Interlocking Wiper (1) Turn Wiper Enable Washer switch ON the input of Washe 0.2sec, turn the ou after T3.But, ignore occurred while Wip operated and acce switch after operat 2010 > G 1.6 DOHC > Body Electrical System Language Removal Disconnect the negative (-) battery terminal Remove the center air vent (B) using the SST (A) (09840-1M100) (Refer to the Body group - Crash pad) Always use the SST(09840-1M100) to prevent the damage when rem Body group - Crash pad) Remove the crash pad center facia panel (A) Take care not to scratch the crash pad and related parts 4 Disconnect the connectors(A) from the crash pad center facia panel and heater control unit Remove the body control module (A) after loosening nuts and disconnecting connector Installation Install the body control module Install the center fascia panel Install the air vent Inspection BCM Connectors Pin Connector A Connector B Connector C Connector D B+ RL door switch IGN2 Horn Relay Driver door Key Lock switch Rear Fog switch Wiper INT switch Tail Lamp Relay Assist door Key Lock switch AutoLight switch - Door Unlock State Power window door Lock switch Front Deicer switch ACC Defogger Relay Driver door Unlock switch AutoLight Signal Inhibit P Door Unlock Relay RR door Unlock switch Wiper INT Volume Inhibit R Trunk Release Relay Assist door switch Driver SeatBelt IND Washer switch Front Fog Lamp Relay Trunk switch Speed sensor Mist switch Power window Relay Tail switch Front Fog switch Reserve switch Key Solenoid 10 Crash Input HeadLamp switch Inhibit D - 11 Key Interlock switch Driver Seat Belt switch Inhibit N AutoLightState 12 CAN H Defogger switch Stop switch Hazard Relay 13 CAN L Auto light GND GND 14 A IGN1 ALT L Front Deicer Relay 15 Driver door Key Unlock switch K Line Door Lock Relay 16 Assist door Key Unlock switch Code Save Driver door Unlock Relay 17 Power window door Unlock switch Rear Fog Lamp Relay 18 Assist door Unlock switch Key Hole Illumination Lamp 19 Driver door switch Head Lamp Low Relay 20 RR door switch Wiper Relay 21 Trunk Release switch 22 Key In switch 23 Start Stop Button 24 Head Lamp High switch 25 - 26 GND Terminal Voltage ATM Solenoid - FntoFnto PnNmPnNm Saett B+ VlaeLvlotg ee 8V ~ 16V - - 0V ~ 5V - - IntT 0V ~ 5V - - IGN1 8V ~ 16V 2V Below 6V Over AltL 8V ~ 16V 5V Below 10V Over ACC 8V ~ 16V 2V Below 6V Over IGN2 8V ~ 16V 2V Below 6V Over Washer Switch OPEN/ON 2.5V Below 8V Over WiperInt Switch OPEN/ON 2.5V Below 8V Over Mist Switch OPEN/ON 2.5V Below 8V Over KeyIn Switch OPEN/ON 2.5V Below 6V Over Trunk Switch OPEN/ON 2.5V Below 6V Over Driver Door Unlock Switch OPEN/ON 2.5V Below 6V Over Assist Door Unlock Switch OPEN/ON 2.5V Below 6V Over RR Door Switch OPEN/ON 2.5V Below 6V Over RL Door Switch Logic Input High Level AutoLightSig Analog Input Low Level OPEN/ON 2.5V Below 6V Over Driver Door Switch OPEN/ON 2.5V Below 6V Over Assist Door Switch OPEN/ON 2.5V Below 6V Over Driver Door Key Lock Switch OPEN/ON 2.5V Below 6V Over Driver Door Key Unlock Switch OPEN/ON 2.5V Below 6V Over Assist Door Key Lock Switch OPEN/ON 2.5V Below 6V Over Assist Door Key Unlock Switch OPEN/ON 2.5V Below 6V Over Pwdw Door Lock Switch OPEN/ON 2.5V Below 6V Over Pwdw Door Unlock Switch OPEN/ON 2.5V Below 6V Over Defogger Switch OPEN/ON 2.5V Below 6V Over Deicer Switch OPEN/ON 2.5V Below 6V Over Driver Seat Belt Switch OPEN/ON 2.5V Below 6V Over AutoLight Switch 6V Over OPEN/ON 2.5V Below 6V Over Head Lamp High Switch OPEN/ON 2.5V Below 6V Over Tail Switch OPEN/ON 2.5V Below 6V Over Rear Fog Switch OPEN/ON 2.5V Below 6V Over Front Fog Switch OPEN/ON 2.5V Below 6V Over Key Inter Lock Switch OPEN/ON 2.5V Below 6V Over Push Start Switch OPEN/ON 2.5V Below 6V Over Inhibit D OPEN/ON 2.5V Below 8V Over Inhibit P OPEN/ON 2.5V Below 8V Over Inhibit N OPEN/ON 2.5V Below 8V Over Inhibit R OPEN/ON 2.5V Below 8V Over Speed sensor OPEN/ON 2.5V Below 6V Over CAN H OPEN/ON - - CAN L OPEN/ON - - Crash Input Communication 2.5V Below Head Lamp Switch Frequency OPEN/ON OPEN/ON - - CODE SAVE OPEN/ON - - K LINE OPEN/ON - - ... Below 6V Over CAN H OPEN/ON - - CAN L OPEN/ON - - Crash Input Communication 2.5V Below Head Lamp Switch Frequency OPEN/ON OPEN/ON - - CODE SAVE OPEN/ON - - K LINE OPEN/ON - - ... Button 24 Head Lamp High switch 25 - 26 GND Terminal Voltage ATM Solenoid - FntoFnto PnNmPnNm Saett B+ VlaeLvlotg ee 8V ~ 16V - - 0V ~ 5V - - IntT 0V ~ 5V - - IGN1 8V ~ 16V 2V Below 6V Over... switch signals controlling time and alarm functions for wiper control, tail lamp auto cut, auto light control, front fog lamp, rear fog lamp, IGN key hole illumination, buzzer control, seat belt