Đang tải... (xem toàn văn)
- THÔNG TIN MÃ LỖI - KIỂM TRA BẰNG MÁY CHẨN ĐOÁN - KIỂM TRA BẰNG SƠ ĐỒ MẠCH ĐIỆN - KIỂM TRA CẢM BIẾN
Page 11/4/2012 9:52:17 PMhttp://kia-hotline.com/Main/Viewer/content.asp?IsPrint=true&vehicletype=Passenger&mfrcode=KM&area=KME&langcode= . 2009 > G 1.1 SOHC > Steering > Electronic Power Steering > Language Monitor Scantool Data1. Connect scantool to Data Link Connector(DLC) and start engine.2. Monitor the "STEERING WHEEL TORQUE" parameter on the scantool.3. Operate the steering wheel to the left and right.a. Specification : Approx. 9.0 Nm ~ 9.0 Nm ( ""means Turning steering wheel to left.)Fig.1) Normal current dataFig.2) Current characteristic chartCheck whether the target current magnitude is the same as the motor current magnitude, refer current characteristic chart according to present the vehiclespeed and the toque sensor.4. Is parameter within specifications?▶Fault is intermittent and caused either by poor contact in connectors or wiring harness, or it has been repaired and EPS CM memory is not cleared yet.Thoroughly check all connectors (and connections) for looseness, bending, corrosion, contamination, deterioration, and/or damage.▶Repair or replace as necessary and then go to "Verification of Vehicle Repair" procedure.▶Go to "W/Harness Inspection" procedure. . Page 11/4/2012 9:52:17 PMhttp:/ /kia- hotline.com/Main/Viewer/content.asp?IsPrint=true&vehicletype=Passenger&mfrcode=KM&area=KME&langcode=...