1. Trang chủ
  2. Kỹ Thuật - Công Nghệ

Design Guide for Fabrication, assembly and erection of structures

173 517 0
Design Guide for Fabrication, assembly and erection of structures

Đang tải... (xem toàn văn)

Tài liệu hạn chế xem trước, để xem đầy đủ mời bạn chọn Tải xuống

Thông tin tài liệu

Hướng dẫn thiết kế cho gia công tổ hợp và lắp đặt kết cấu bằng tiếng Anh.Design Guide for Fabrication, assembly and erection of hollow section structures. Design guide for circular hollow section (CHS) joints under predominantly static loading. Structure stability of hollow sections. Design guide for rectangular hollow section (RHS) joints under predominantly static loading. Design guide for structural hollow section columns exposed to fire. Design guide for concrete filled hollow sections columns under static and seismic loading. Design guide for structural hollow sections in mechanical appplications. Design guide for fabrication, assembly and erection of hollow section structures. Design guide for circular and rectangular hollow section joints under fatigue loading (in preparation).

Ngày đăng: 26/02/2017, 13:25

Xem thêm: Design Guide for Fabrication, assembly and erection of structures

Từ khóa liên quan

Mục lục

  • Preface

  • Contents

  • 1 Introduction

  • 2 Structural hollow section steel grades and dimensional tolerances

    • 2.1 Steel grades

      • 2.1.1 Welding considerations for the materials

      • 2.2 Sectional dimensions and properties

        • 2.2.1 Dimensional tolerances

        • 3 Structural hollow section fabrication methods

          • 3.1 Cutting

            • 3.1.1 Plane cut by sawing

            • 3.1.2 Flame cutting

              • 3.1.2.1 Manual flame cutting

              • 3.1.2.2 Automatic flame cutting

              • 3.1.3 Slotting

              • 3.1.4 Laser cutting

              • 3.1.5 Plasma cutting

              • 3.2 Flattening

                • 3.2.1 Cropping

                • 3.2.2 Full flattening

                • 3.2.3 Flattening with a recessed die

                • 3.2.4 Partial flattening

                • 3.3 Bending (arching)

                  • 3.3.1 Cold bending methods for CHS

                    • 3.3.1.1 Cold bending by pressing

                    • 3.3.1.2 Cold bending by a "former" box

                    • 3.3.1.3 Roller bender

                    • 3.3.1.4 Bending by means of mitre cuts

                    • 3.3.2 Cold bending methods for RHS

                      • 3.3.2.1 Roller bending

Tài liệu cùng người dùng

Tài liệu liên quan