Chapter 3 the classification of clastic sedimentary rocks

50 408 0
Chapter 3 the classification of clastic sedimentary rocks

Đang tải... (xem toàn văn)

Tài liệu hạn chế xem trước, để xem đầy đủ mời bạn chọn Tải xuống

Thông tin tài liệu

Chapter 3: The Classification of Clastic Sedimentary Rocks A very basic classification of all sedimentary rocks is based on the type of material that is deposited and the modes of deposition Classification based on grain size A simple classification of terrigenous clastic rocks and sediment is based on the predominant grain size of the material: Grain Size1 (mm) Sediment name Rock Name Adjectives >2 Gravel Rudite Cobble, pebble, well sorted, etc 0.0625-2 Sand Arenite Coarse, medium, well sorted, etc < 0.0625 Mud Mudstone or Lutite Silt or clay For the purposes of this general classification we will assign the rock or sediment name shown if more than 50% of the particles are in the range shown More detailed classification schemes will limit terms on the basis of different proportions of sediment within a given grain size Classification of Sandstones Most sandstone classifications are based on the composition of the rock Dott’s classificaton scheme is used in most courses at Brock It is based on the relative proportions of: Martrix (fine-grained - 75 Example Point Count Data: Component Number of Proportion Grains counted (%) Quartz 73 26 Feldspar 56 20 Rock fragments 34 12 Matrix 118 42 Total: 281 100 A first order classification is based on the proportion of matrix that is present: % matrix Rock Name < 15 Arenite 15 - 75 Wacke or Graywacke Mudstone >75 To classify Arenites and Graywacke’s on the basis of their specific compositions the data must be “normalized” to 100% quartz, feldspars and rock fragments A Total Rock Component Quartz A Quartz, feldspars and rock fragments Proportion (%) 26 Component Quartz Proportion1 (%) 45 Feldspar 20 Feldspar 34 Rock fragments 12 Rock fragments 21 Matrix 42 ∴ a graywacke Total: Total: 100 100 Total Q, F, and Rf: 58 Calculated as the proportion of each component in the total rock divided by the total proportion of quartz, feldspars and rock fragments (in this case that total is The next step is to plot the normalized data on a ternary diagram to determine the specific field in which the data fall Classification of Rudites Rudites are classified on the basis of particle shape, packing and composition Conglomerate A rudite composed predominanty of rounded clasts Rounded clasts may indicate considerable distance of transport from source The significance will vary with the lithology of the clast (i.e., limestone clasts will become round a short distance from their source whereas quartzite will require much greater transport) http://www.geographyinaction.co.uk/Assets/Photo_albums/Seven/pages/Conglomerate_jpg.htm Breccia A rudite composed predominantly of angular clasts Generally indicates that the clasts have not traveled far from their source or were transported by a non-fluid medium (e.g., gravity or glacial ice) http://homepage.smc.edu/robinson_richard/rocktest/igneous_web/pages/breccia.html Diamictite A rudite composed of poorly sorted, mud to gravel-size sediment, commonly with angular clasts Commonly refers to sediment deposited from glaciers or sediment gravity flows, particularly debris flows http://www-eps.harvard.edu/people/faculty/hoffman/Snowball-fig11.jpg Note: in the following the rock names are given for rudites consisting of rounded clasts (conglomerates) but the term conglomerate may be replaced with the term "breccia" if the clasts comprising the rock are angular Orthoconglomerate A conglomerate in which all clasts (clast-supported are in contact with other clasts conglomerate) (i.e., the clasts support each other) Such conglomerates may have no matrix between clasts (open framework) or spaces between clasts may be filled by a matrix of finer sediment (closed framework) Clast-supported framework is typical of gravels deposited from water flows in which gravel-size sediment predominates Open framework suggests an efficient sorting mechanism that caused selective removal of finer grained sediment Closed framework suggests that the transporting agent was less able to selectively remove the finer fractions or was varying in competence, depositing the framework-filling sediment well after the gravel-size sediment had been deposited Orthoconglomerate with open framework http://seis.natsci.csulb.edu/rbehl/cong.htm Paraconglomerate (matrix-supported conglomerate) A conglomerate in which most clasts are not in contact; i.e., the matrix supports the clasts Typical of the deposits of debris flows or water flows in which gravel size clasts were not abundant in comparison to the finer grain sizes http://www.science.uwaterloo.ca/course_notes/earth/earth390/6.GIF Polymictic conglomerate A conglomerate in which clasts include several different rock types Conglomerates that include clasts from a wide-variety of source rocks, possibly derived over a wide geographical area or a smaller but geologically complex area Oligomictic conglomerate A conglomerate in which the clasts are made up of only one rock type Suggests that the source area was nearby or source rock extended over wide geographic area http://graduate.eas.ualberta.ca/rhartlaub/Rae/QPL.JPG Intraformational conglomerate A conglomerate in which clasts are derived locally from within the depositional basin (e.g., clasts composed of local muds torn up by currents; such clasts are commonly termed "rip-up clasts" or "mud clasts") Deposition in an environment where muds accumulated Muds were in very close proximity to the site of deposition as the clasts would not withstand considerable transport http://www.yuprocks.com/ilist/ic1.html Extraformational Conglomerate A conglomerate in which clasts are exotic (i.e., derived from outside the depositional basin) Clasts are normally very well rounded and well sorted Clasts derived from a distant source Classification of Lutites For our purposes, familiarity with terminology will suffice: Shale: The general term applied to this class of rocks (> 50% of particles are finer than 0.0625 mm) Lutite: A synonym for "shale" Mud: All sediment finer than 0.0625 mm More specifically used for sediment in which 33-65% of particles are within the clay size range (68% of particles fall within the silt size range (0.0625 - 0.0039 mm) Clay: All sediment finer than 0.0039 mm Fissility: planes Refers to the tendency of lutite to break evenly along parting The greater the fissility the finer the rock splits; such a rock is said to be "fissile" Mudstone: A bocky shale, i.e., has only poor fissility and does not split finely Argillaceous sediment: A sediment containing largely clay-size particles (i.e., >50%) Argillite: A dense, compact rock (poor fissility) composed of mud-size sediment (low grade metamorphic rock, cleavage not developed) Psammite: Normally a fine-grained sandstone but sometimes applied to rocks of predominantly silt-size sediment Siltstone: A rock composed largely of silt size particles (68-100% silt-size) Lutite terms based on proportion of clay, degree of induration and thickness of stratification Terminology related to stratification and fissility (parting) [...].. .The next step is to plot the normalized data on a ternary diagram to determine the specific field in which the data fall If the proportion of matrix is less than 15% plot the data and use Dott’s diagram for the classification of arenites If the proportion of matrix is less than 15% plot the data and use Dott’s diagram for the classification of arenites If the proportion of matrix is... than 15% plot the data and use Dott’s diagram for the classification of arenites If the proportion of matrix is less than 15% plot the data and use Dott’s diagram for the classification of arenites This classification is based on the major component of most sandstones and provides a basis for a consistent nomenclature for sandstones The names can be modified to reflect other components of the rock: e.g.,... feldspar content in sands in eastern and southern North America Overall, there is a reduction in the proportion of feldspar in sands towards the south Several factors at work: Source rocks: in the north are more granitic source rocks whereas in the south the major source rocks are Paleozoic sedimentary rocks Climate: colder in the north so that physical weathering is important, producing immature sediment... down source rocks by physical processes Warmer in the south so that chemical weathering produces a more mature sediment Transport distance: the south has many rivers that have transported sediment over long distances, increasing the maturity of the sands (e.g., Colorado River, Rio Grande, Mississippi River) II Genetic Classification of sedmentary rocks Classification on the basis of how the rocks were... http://cima.uprm.edu/~morelock/8_image/7turb.jpg c) Storm Beds (Tempestites) The lithified deposits of storms influencing a shallow marine environment Independent of grain size or lithology Genetic classification of sedimentary rocks requires a knowledge of the depositonal setting and cannot normally be made on the basis of hand specimens alone III Which classification should you use? This depends on the purpose of the study that you are participating... sandstones on the basis of grain size only Studies that aim to reconstruct ancient tectonic settings require a detailed analysis of the composition of the sandstones Some studies require compositional classification in order to understand the mechanical properties of the sandstone (e.g., if the study aims to determining excavation costs) Classification of Rudites Rudites are classified on the basis of particle... weathering and is the most common mineral in most sedimentary rocks Potassium feldspar is also common but Muscovite is relatively soft and breaks down during transport The stability of rock fragments varies with their mineralogy The most “mature” sediment would be made up of 100% quartz grains With increased transport and number of times through the rock cycle the less stable minerals are lost The. .. reflect the source rock and tectonic and climatic characteristics of the source area for the sediment i) Tectonic setting The source rock of a sediment and the tectonic setting are closely linked: the tectonic setting determines the relative abundance of different types of rock that is available for weathering and the production of clastic sediment e.g., An arkosic sandstone (rich in feldspars) would... times Clastic sedimentary rocks can be made up of “multicycled” particles i.e., have passed through the rock cycle several times Each time through the cycle the sediment becomes more and more mature Sediment texture and mineralogical composition all reflect the maturity of a sediment Most changes are related to transport distance, nature of weathering at the site of sediment formation and number of passes... chemically unstable grains The fewer the soft or unstable grains, the more mature the sediment What is the relative stability of minerals? Bowen’s Reaction series shows the sequence in which minerals crystallize from a cooling magma Mineral stability can also be shown using Bowen’s Reaction series: The earliest minerals to crystallize are the least stable Quartz is the most stable of the common mineral;

Ngày đăng: 30/11/2016, 16:52

Từ khóa liên quan

Mục lục

  • Slide 1

  • Slide 2

  • Slide 3

  • Slide 4

  • Slide 5

  • Slide 6

  • Slide 7

  • Slide 8

  • Slide 9

  • Slide 10

  • Slide 11

  • Slide 12

  • Slide 13

  • Slide 14

  • Slide 15

  • Slide 16

  • Slide 17

  • Slide 18

  • Slide 19

  • Slide 20

  • Slide 21

  • Slide 22

  • Slide 23

  • Slide 24

  • Slide 25

  • Slide 26

  • Slide 27

  • Slide 28

  • Slide 29

  • Slide 30

  • Slide 31

  • Slide 32

  • Slide 33

  • Slide 34

  • Slide 35

  • Slide 36

  • Slide 37

  • Slide 38

  • Slide 39

  • Slide 40

  • Slide 41

  • Slide 42

  • Slide 43

  • Slide 44

  • Slide 45

  • Slide 46

  • Slide 47

  • Slide 48

  • Slide 49

  • Slide 50

Tài liệu cùng người dùng

  • Đang cập nhật ...

Tài liệu liên quan