ATM LANE Key Commands Shows and Debugs On Router: Interface atm 0 Atm pvc 1 0 5 qsaal Atm pvc 2 0 16 ilmi LECS Lane database my_database Name elan1 server-atm-address 47.000… (check def) Name élan2 server-atm-address 47.000 <- LES addres ! start LECS interface atm 0 lane config my_databse lane config auto-config-atm-address Start LES/BUS: Interface atm 0.1 multipoint Lane server-bus Ethernet élan1 Start LEC: Interface atm 0.2 multipoint Lane client Ethernet elan1 Show lane default <- very important Show atm arp Debug atm arp Show lane client Show lane server (for LES) Show lane config (for LECS) Show lane database (on LECS) Show lane bus Show lane le-arp Show lane interface Additional Commands On LANE module: Exact same configs as on a router, except for LEC: Interface atm 0.1 multipoint Lance client Ethernet 1 elan1 Maps the vlan 1 to elan1! Then can use sc0 in vlan1 On 1010, to point to the LECS through well known: Atm lecs-address-default 47.000… On LECS, if want to use a different address, use: Lane config fixed-atm-address Spot The Issue Notes When using “lane config auto-config-atm-address” in the LECS definition, this assumes that the 1010 switch is providing the LECS’ address through the “well known NSAP address”. On the 1010, use “atm lecs-address-default 47.000…” and point to the nsap address of the LECS router. Use “show lane default” on the router and cut and paste!! Élan names are CASE SENSITIVE The selector byte is the number of the sub- interface on which the service resides. In HEX!! • If possible (allowed) put all Lane services on the same router instead of spreading it. • You MUST put the services under sub- interfaces except for LECS. • Write down the sub-interface # because it matters with the NSAP address of services when mapping them. Check “show lane default” to see the default nsap addresses with .** • The value of the selector byte corresponds to the sub-interface number of the atm interface • Notice that in “show lane default”, the LECS address is .00 while all others are .**. This is because the LECS goes on the major interface, while all others go on the sub interface. . Show lane default <- very important Show atm arp Debug atm arp Show lane client Show lane server (for LES) Show lane config (for LECS) Show lane. ATM LANE Key Commands Shows and Debugs On Router: Interface atm 0 Atm pvc 1 0 5 qsaal Atm pvc 2 0 16 ilmi LECS Lane database