...
Turn debug frame- relay packet off.
Singapore#no debug frame- relay packet or no debug all
4. Based upon the map being dynamically established and output from the
debug frame- relay packet ... determine whether a
frame- relay map or frame- relay interface-dlci command
was used in the router configuration? (Hint: Inverse ARP.)
Since you have determined a fra...
... PVC.
Step 8 Show the Frame Relay maps
a. Look at the frame relay maps by typing the command show frame- relay map at the privileged
EXEC mode prompt:
Amsterdam#show frame- relay map
b. What ...
Berlin(config-router)#network 192.168.6.0
Step 7 Verifying Frame Relay PVC
a. On the Amsterdam router, issue the command show frame- relay pvc:
Amsterdam#show fra...
...
Show frame- relay pvc Command Field Descriptions
Field Description
DLCI
One of the DLCI numbers for ... this PVC
Dropped Pkts
Number of incoming and outgoing packets dropped by the router at the Frame
Relay level
In FECN Pkts
Number of packets received with the FECN bit set
In BECN Pkts
... address via a “static”
frame- relay map statement. “CISCO” identifies the Frame Relay
encapsulation used with frame- relay map statement, which is the default
Frame Relay encapsulation on Cisco ... broadcast
frame- relay lmi-type ansi
Remove the incorrect frame- relay map statement.
Singapore(config-if)#no frame- relay map ip 192.168.192.2 17 broadcast
Reen...
... encapsulation frame- relay
no ip mroute-cache
cdp enable
frame- relay interface-dlci 18
frame- relay lmi-type ansi
As was discovered earlier, the encapsulation is frame- relay and the frame- relay ... information about each router.
• show interface
• show frame- relay lmi
• show frame- relay pvc
• show frame- relay map
• debug frame- relay lmi
G...
... 5.2.1 Configuring Frame Relay
Objective
• Configure a router to establish a connection to a local Frame Relay switch.
Background/Preparation
An Adtran Atlas550 Frame Relay emulator is used ...
a. In Frame Relay, the customer router is considered the DTE device. In order to configure the
serial interface the Layer 2 Frame Relay frame type must be defined. To config...
... Configuring Frame Relay PVC
Objective
• Configure two routers back-to-back as a Frame Relay permanent virtual circuit (PVC). This will
be done manually, in the absence of a Frame Relay switch, ... the Frame Relay frame type to be used on this link. To configure the encapsulation type,
use the command encapsulation frame- relay ietf. Disable keepalive messages sinc...
... Configuring Frame- Relay Subinterfaces
Objective
• Configure three routers in a full-mesh Frame Relay network.
An Adtran Atlas550 Frame Relay emulator is used to simulate the switch /Frame Relay ... PVC.
Step 8 Show the Frame Relay maps
a. Look at the frame relay maps by typing the command show frame- relay map at the privileged
exec mode prompt:
Amsterdam#...