... machines,provisions 6 and 7 are combined in one unit)8. Provision for heating the plastic in the plasticizing unit9. Cycle controls (sequencing logic, timers, etc.) and a command post formanual operation and ... 28.11.2005, 10:47361 Introduction and PlanningThere are other features available, e.g., for the convenience of quick moldinstallation, setting up and operation of the mold and machine; these featuresare ... frequently, precedents from earlier moldsare used and reapplied. However, the mold designer must be aware of and evaluate new ideas, new methods, and developments, which when appliedwould lead...