...
Activity 10. 1: Creating and Distributing
Preliminary Components
In this activity, you will place candidate components into service layers
assigned in a previous activity.
Objectives ... this activity: 20 minutes followed by a 10 minute
discussion.
THIS PAGE INTENTIONALLY LEFT BLANK
Activity 10. 1: Creating and Distributing Preliminary Componen...
... can be used in IOS command to represent the interface.
4 - 4 CCNA 2: Routers and Routing Basics v 3.0 - Lab 10. 1.6 Copyright 2003, Cisco Systems, Inc.
Erasing and reloading the router ... configuration mode and configure the hostname as
shown in the chart. Then configure the console, virtual terminal, and enable passwords.
Configure the Ethernet interface.
1 - 4 CCNA 2: R...
...
directions and courses
of actions
Activity 3 .1: Identifying Data-Related
Use Cases and Data Requirements
In this activity, you will analyze a set of use cases derived from the Ferguson
and ...
Before You Begin
Time to complete this activity: 20 minutes
8 Activity 3 .1: Identifying Data-Related Use Cases and Data Requirements
Exercise 1:
Identifying Us...
...
Activity 10. 2: Distributing Components
for Performance
In this activity, you will reorganize your candidate components to take into
account additional ... service layer topology created in Activity 6.3
!
The component topology created in Activity 10. 1
Time to complete this activity: 10 minutes followed by a 10 minute
discussion.
... small group tasks and cla...
... Labfiles check box, and then select the Labfiles check box again
to select the Labfiles folder and its entire contents.
10 Module 10: Backing Up and Restoring Data
Performing Preliminary Tasks ... data, and then click Next to continue.
6. The Backup wizard displays the Items to Backup page, prompting you to
select the local and network drives, folders, and files to be b...
...
Use this space for creating the future-case usage scenarios.
7. THIS PAGE INTENTIONALLY LEFT BLANK
Activity 4.4: Creating a Future-State
Usage Scenario
In this activity, you will ... group tasks and class discussion.
Prerequisites
There are no prerequisites for this activity.
Materials
!
The Ferguson and Bardell, Inc. case study.
Time to complete this activity...
...
Activity 6 .1: Risks of Skipping
Physical Design
In this activity, you will participate in a class discussion to identify the ... physical design and the risks of not completing a
physical design.
Before You Begin
This activity is a class discussion.
Prerequisites
There are no prerequisites for this activity.
Materials ... prerequisites for this activity.
Materials
There...
... remove and store the cables and
adapter. After that, log off and turn the router off.
3 - 4 CCNA 2: Routers and Routing Basics v 3.0 - Lab 10. 1.6 Copyright 2003, Cisco Systems, Inc.
Erasing and ... 2 - 4 CCNA 2: Routers and Routing Basics v 3.0 - Lab 10. 1.6 Copyright 2003, Cisco Systems, Inc.
Step 1 Configure the hostname, passwords and interfaces on the Gadsden rout...
... will discuss the activity with the class.
Activity 8 .1: Simulating Component
Communication
In this activity, you will simulate the communication between components.
This activity will illustrate ... 54 Activity 8 .1: Simulating Component Communication
Exercise 1: Component Communication Before COM
!
Communicate with the other components
1. Participate in ... th...