22 continuous flow heat processing

Inactivation of microorganisms in untreated water by a continuous flow system with supercritical CO2 bubbling

Inactivation of microorganisms in untreated water by a continuous flow system with supercritical CO2 bubbling
... SC -CO2 treatment on the inactivation of coliform bacteria in untreated water is shown in Figure The coliform bacterial count in the untreated water decreased almost linearly with increasing CO2/ sample ... flow rate and exposure time in the SC -CO2 treatment on the inactivation of coliform and total bacteria in untreated water and to propose the SC -CO2 treatment as a novel method for inactivating microorganisms ... treatment with SC -CO2 (Kobayashi et al., 2006) and suggested that inactivation of Escherichia coli in sterile distilled water and coliform bacteria in water prior to treatment at a municipal water...
  • 10
  • 137
  • 0

Formation of Aerobic Granular Sludge in a Continuous-Flow Reactor – Control Strategy for the Selection of Well-Settling Granular Sludge

Formation of Aerobic Granular Sludge in a Continuous-Flow Reactor – Control Strategy for the Selection of Well-Settling Granular Sludge
... Formation of Aerobic Granular Sludge Two AUFB reactors were used for the formation of aerobic granular sludge Air was introduced from the bottom of the reactor, and aeration rate was gradually increased ... in a continuous-flow reactor Both surface loading and aeration rates affect the selection of well-settling sludge and the formation of aerobic granular sludge By setting and controlling adequate ... decided the control strategy for the selection of well-settling sludge Then, we applied the strategy to the formation of aerobic granular sludge in a continuous experiment In addition, the effect of...
  • 8
  • 144
  • 0

Báo cáo y học: " Myocardial recovery in peri-partum cardiomyopathy after continuous flow left ventricular assist device" pps

Báo cáo y học:
... Page of 10 Myocardial recovery in peri-partum cardiomyopathy after continuous flow left ventricular assist device Lars H Lund1*, Karl-Henrik Grinnemo2 , Peter Svenarud2 , Jan van der Linden2 , ... for recovery Keywords: Peri-partum cardiomyopathy; heart failure; recovery; left ventricular assist device; mechanical circulatory support Page of 10 Background Peri-partum cardiomyopathy: Peri-partum ... transplantation, LVEF may improve but generally does not normalize [1] Recovery with LVAD: In non-ischemic cardiomyopathy, myocardial injury may be reversible Sustained LV unloading from pulsatile...
  • 11
  • 98
  • 0

Báo cáo y học: "Acute and critically ill peripartum cardiomyopathy and ‘bridge to’ therapeutic options: a single center experience with intra-aortic balloon pump, extra corporeal membrane oxygenation and continuous-flow left ventricular assist devices" pp

Báo cáo y học:
... cardiomyopathy and ‘bridge to’ therapeutic options: a single center experience with intra-aortic balloon pump, extra corporeal membrane oxygenation and continuous-flow left ventricular assist devices ... Lawal AH, Bhandari A, Hawkins JL, Atlee JL: Case 1—2002 a patient with severe peripartum cardiomyopathy and persistent ventricular fibrillation supported by a biventricular assist device J Cardiothorac ... Feldman AM, Hutchins GM, Baughman KL: Peripartum myocarditis and cardiomyopathy Circulation 1990, 81:922-928 Sliwa K, Skudicky D, Bergemann A, Candy G, Puren A, Sareli P: Peripartum cardiomyopathy: ...
  • 7
  • 104
  • 0

Immobilizing catalysts in continuous flow micro reactors polymer encapsulated metals and engineered biofilms

Immobilizing catalysts in continuous flow micro reactors polymer encapsulated metals and engineered biofilms
... to use continuous processes Continuous processes using flow reactors refer to processes in which the products are being produced continuously Since there is no need to halt the reactions in order ... scale in the pharmaceutical and fine chemicals industry In a CSTR, substrate mixture is continuously fed into a tank and product is also continuously removed from the outlet of the reactor Mixing ... 24 distinct integrins 167 Figure 7-2 Interaction between the cyclo(RGDf-N{Me}V) ligand (yellow sticks) and αvβ3 integrin αv and β3 residues are labeled blue and red, respectively Oxygen and nitrogen...
  • 240
  • 36
  • 0

SCALABLE CONTINUOUS FLOW PROCESSES FOR MANUFACTURING PLASMONIC NANOMATERIALS

SCALABLE CONTINUOUS FLOW PROCESSES FOR MANUFACTURING PLASMONIC NANOMATERIALS
... Laminar flows with high Pe, where only molecular diffusion is dominant has been used for laminar flow patterning where confinement between the co-flowing laminar flows is important; for careful ... synthesis using wet chemical batch methods and the need for microfluidic continuous flow techniques were discussed The continuous flow methods for gold nanoparticle and gold nanoshell synthesis have ... droplet flow over single flow regime for solid nanomaterials synthesis 3.4 Gold nanoshell synthesis For the synthesis of silica-gold nanoshells, a protocol established by Halas group for batch...
  • 94
  • 20
  • 0

Effect of periodic suction on three dimensional flow and heat transfer past a vertical porous plate embedded in a porous medium

Effect of periodic suction on three dimensional flow and heat transfer past a vertical porous plate embedded in a porous medium
... Bull Malays Math Sci Soc 2006, 29(1), 33-42 [15] Das S S., Satapathy A. , Das J K., Panda J P Mass transfer effects on MHD flow and heat transfer past a vertical porous plate through a porous medium ... 927-941 [9] Sattar M A Free convection and mass transfer flow through a porous medium past an infinite vertical porous plate with time dependant temperature and concentration Ind J Pure Appl Math 1994, ... adjacent to a semi-infinite vertical plate Mech Res Comm 1987, 14, 9-16 [7] Govindarajulu T., Thangaraj C J The effect of variable suction on free convection on a vertical plate in a porous medium...
  • 12
  • 154
  • 0

Finite time exergoeconomic performance optimization for an irreversible universal steady flow variable-temperature heat reservoir heat pump cycle model

Finite time exergoeconomic performance optimization for an irreversible universal steady flow variable-temperature heat reservoir heat pump cycle model
... Conclusion Finite time exergoeconomic performance of an irreversible universal steady flow heat pump cycle model with variable-temperature heat reservoirs, and the losses of heat transfer and internal ... U L = and x = y = , equations (30) and (33) become the COP and finite time exergoeconomic performance of an irreversible variable-temperature heat reservoir steady flow Otto heat pump cycle with ... and y = , equations (30) and (33) become the COP and finite time exergoeconomic performance characteristics of an irreversible variable-temperature heat reservoir steady flow Dual heat pump cycle...
  • 18
  • 167
  • 0

Heat transfer and friction factor characteristics using continuous M shape ribs turbulators at different orientation on absorber plate solar air heater

Heat transfer and friction factor characteristics using continuous M shape ribs turbulators at different orientation on absorber plate solar air heater
... E-Electric Heater A-Ammeter V-Voltmeter MM- Micro Manometer Figure (a) Schematic view of experimental apparatus of solar air heater (b) Sectional view of duct An electric heater 1000 mm × 160 mm is made ... element on absorber plate of solar air heater Karmare and Tikekar [16] reported an experimental investigation and developed correlation for heat transfer coefficient and friction factor for metal ... K.R, Gandhi B.K, Saini J.S Heat transfer and friction characteristics of solar air heater duct having integral inclined discrete ribs on absorber plate International Journal of Heat and Mass Transfer...
  • 16
  • 190
  • 0

Natural convection unsteady magnetohydrodynamic mass transfer flow past an infinite vertical porous plate in presence of suction and heat sink

Natural convection unsteady magnetohydrodynamic mass transfer flow past an infinite vertical porous plate in presence of suction and heat sink
... free convection flow past an infinite vertical plate with constant suction and mass transfer Int J Heat Mass Trans.1977, 20, 1363-1373 [5] Hossain M A., Begum R A Effect of mass transfer and free ... convection mass transfer flow of a viscous incompressible electrically conducting fluid past an infinite vertical porous plate in presence of constant suction and heat sink and a transverse magnetic ... constant suction and mass transfer Hossain and Begum [5] estimated the effect of mass transfer and free convection on the flow past a vertical plate Bestman [6] analyzed the natural convection boundary...
  • 14
  • 126
  • 0

An experimental investigation of heat transfer and fluid flow in a rectangular duct with inclined discrete ribs

An experimental investigation of heat transfer and fluid flow in a rectangular duct with inclined discrete ribs
... rib arrangements on heat transfer and flow behavior in a rectangular rib roughened passage” International Journal of Heat and mass transfer; 123: 675-681, 2001 [6] Lau S.C., McMillin R.D and Han ... studies of augmented heat transfer and friction in asymmetrically heated rectangular ducts with ribs on the heated wall in transverse, inclined, V-continuous and V- discrete pattern Int Journal of Heat ... Tariq, A. , Keshav Kant and Panigrahi, P K., Heat transfer enhancement using an internally threaded tube”, Proceeding of the 4th ISHMT-ASME and 15th National Conference on Heat and Mass transfer...
  • 12
  • 236
  • 0

Hydromagnetic convective flow past a vertical porous plate through a porous medium with suction and heat source

Hydromagnetic convective flow past a vertical porous plate through a porous medium with suction and heat source
... transfer to unsteady magneto-hydrodynamic flow past an infinite vertical moving plate with variable suction Das and his co-workers [16] estimated the mass transfer effects on unsteady flow past ... the variation of the flow parameters such as Prandtl number Pr, magnetic parameter M, permeability parameter Kp and heat source parameter S The variations in the temperature of the flow field are ... Sarangi K C., Jose C B Unsteady free convective MHD flow and mass transfer past a vertical porous plate with variable temperature Bull Cal Math Soc.2005, 97 (2), 137-146 [15] Ogulu A. , Prakash...
  • 12
  • 177
  • 0

The Thermodynamics, Heat Transfer, and Fluid Flow Fundamentals Handbook

The Thermodynamics, Heat Transfer, and Fluid Flow Fundamentals Handbook
... THERMODYNAMICS, HEAT TRANSFER, AND FLUID FLOW OVERVIEW The Department of Energy Fundamentals Handbook entitled Thermodynamics, Heat Transfer, and Fluid Flow was prepared as ... fully understand the impact that their actions may have on the safe and reliable operation of facility components and systems The Thermodynamics, Heat Transfer, and Fluid Flow handbook consists ... HT THERMODYNAMICS, HEAT TRANSFER, AND FLUID FLOW The information contained in this handbook is by no means all encompassing An attempt to present the entire subject of thermodynamics, heat transfer,...
  • 274
  • 112
  • 0

Acta Montanistica Slovaca: Heat - Integrated Design for Natural Gas Processing pot

Acta Montanistica Slovaca: Heat - Integrated Design for Natural Gas Processing pot
... refrigeration Exchanger E-1A E-1B E-2A E-2B Total Tab 3: Comparison of the energy requirements in MW of the original design with the heat integrated design Initial Design Heat- Integrated Design Refrigerant ... required to cool or heat a process stream we used a simplified model of heat exchanger COOLER for E-1A, E-1B and HEATER for E-2A, E-2B For modeling of flash vessels S-1, S-2 we used model SEPARATOR ... so that heat exchangers for heating of outlet streams of the first separator S-1 economize heat of gas heated in compressor It was necessary to use the full value HEAT EXCHANGER weighed design...
  • 4
  • 158
  • 0

Xem thêm

Nạp tiền Tải lên
Đăng ký
Đăng nhập