Modelling and optimisation of biomass fluidised bed gasifier

An experimental study on catalytic bed materials in a biomass dual fluidised bed gasifier

An experimental study on catalytic bed materials in a biomass dual fluidised bed gasifier
... al Tar measurement standard for sampling and analysis of tars and particles in biomass gasification product gas In: 14th European Biomass Conference Proceedings Paris, France; 2005 Freda C, Fanelli ... case that calcium enriches in the ash layer covering bed material particles, the catalytic reforming of tar can be enhanced to a great degree The behaviour of catalytic and non -catalytic bed materials ... Virginie M, Gallucci K, Courson C, Di Marcello M, Kiennemann A, et al Fe/olivine catalyst for biomass steam gasification: preparation, characterization and testing at real process conditions Catal...
  • 11
  • 32
  • 0

Modelling and verification of single slope solar still using ANSYS-CFX

Modelling and verification of single slope solar still using ANSYS-CFX
... annually cost of distillate output of Inverted absorber solar still and single slope solar still were 0.95 & 0.54 Rs A.J.N Khalifa[10] studied literature on relation between cover tilt angle and productivity ... the distillate water to an external measuring jar Whole set up of solar still is installed on stand   Figure Experimental set up of solar still Flow geometry ANSYS is engineering simulation software, ... Figure shows dimensional model of solar still based on data available in experimental set up of solar still by ANSYS 10 Figure shows meshing structure of solar still ISSN 2076-2895 (Print), ISSN...
  • 14
  • 187
  • 0

Tài liệu Design and optimisation of conformal cooling channels in injection muolding tools docx

Tài liệu Design and optimisation of conformal cooling channels in injection muolding tools docx
... effectiveness of conformal cooling channels and selective laser sintering material in injection moulding tools, RPD (2002) 1–5 [6] F Jacobs, High-conductivity Materials and Conformal Cooling Channels, ... paid to designing corners and the cooling system in these areas On the issue of dimensional criteria in designing cooling channels, three dimensions have to be considered: the diameter of the ... sizing and positioning of cooling channels With the same instrument, optimal processing conditions in the cooling operation was found, minimising functions linked to process quality and productivity...
  • 7
  • 241
  • 0

New trends on urban goods movement: modelling and simulation of e-commerce distribution docx

New trends on urban goods movement: modelling and simulation of e-commerce distribution docx
... settings: determination of the destinations and modelling of the O-D interactions and single trips Routes construction: their simulation is got by trip chain aggregation The combining of trips to a ... consumer behaviour in the supply chain, Russo and Comi (2004) propose a conceptual analysis of the end-consumer movements between the shops zone (d) and the consumption zone (o) on the one hand, ... improvements on route optimisation and the impacts of trip substitution In this way, a in-depth study of new distribution trends, such as collaboration, logistics sharing and the usage of route optimisation...
  • 23
  • 147
  • 0

Báo cáo hóa học: " Research Article Modelling and Implementation of QoS in Wireless Sensor Networks: A Multiconstrained Traffic Engineering Model" pdf

Báo cáo hóa học:
... to a source and carry the information concurrently to the destination in order to achieve load balancing and rapid delivery of the information In a wireless sensor network, both single paths and ... reveals a gain which increases with the reduction of the play-back delay Note however that while multipath routing may result in playback delay gain, increasing the path multiplicity can increase ... [3] C Intanagonwiwat, R Govindan, and D Estrin, “Directed diffusion: a scalable and robust communication paradigm for sensor networks,” in Proceedings of the ACM/IEEE Annual International Conference...
  • 14
  • 160
  • 0

Modelling and Control of Snake Robots

Modelling and Control of Snake Robots
... within modelling and control of snake robots as steps toward developing snake robots capable of such operations A survey of the various mathematical models and motion patterns for snake robots ... in robots that look and move like snakes snake robots These robots most often have a high number of degrees of freedom (DOF) and they are able to move without using active wheels or legs Snake ... overview of a selection of the results reported on the modelling of dynamics of wheeled snake robots and nally we present results on snake robots without wheels To ease the presentation of the...
  • 192
  • 104
  • 0

Báo cáo khoa học: "Synthesis and analysis of biomass and net primary productivity in Chinese forests" docx

Báo cáo khoa học:
... extant dataset on biomass and NPP of biomes, including 17 major forest types of Biomass and NPP of Chinese forests China, and their analyses and synthesis First, we introduce the existing methodologies ... forest and monsoon forest in Hainan Island and the 358 Table II Statistics of leaf area index (LAI), total biomass and annual net primary productivity (NPP) of 17 Chinese forests Mean is the ... X.K., Wu G., Biomass and primary productivity of forest ecosystems in China, Science Press, Beijing, 1999, 241 p [18] Forestry Ministry of China, Summary of Forest Resources in China (1989–1993),...
  • 34
  • 69
  • 0

Báo cáo sinh học: " Modelling and optimizing of sequential selection schemes: a poultry breeding application" ppt

Báo cáo sinh học:
... asymptotic genetic gain and lags in a multistage poultry breeding plan is described It involves selection of best pairs of mated animals with overlapping generations and BLUP evaluation of candidates ... = among all the and A male is mated with d dams The probability of selecting sire should account for all the possibilities that can arise, based of the dams it is mated with a male as an actual ... of information available for the evaluation is not equal for all candidates (Goffinet and Elsen, 1984; James, 1987) and simultaneously optimizes the generation intervals and the proportions of...
  • 30
  • 82
  • 0

Modelling and control of bioinspired robotic fish underwater vehicle and its propulsion mechanism

Modelling and control of bioinspired robotic fish underwater vehicle and its propulsion mechanism
... Computed-Torque Control (CTM) Model of Robotic fish 158 xiv LIST OF FIGURES 5.2 Feed-forward Control (FF) Model of Robotic fish 161 5.3 Feed-forward plus Computed Torque Control (FF) Model of Robotic ... suitable to both vehicular morphology and methods of locomotion The study of underwater evolution of life and its plethora of locomotion modes has long been a subject of interest to the Biological Community ... system of propulsion for the autonomous underwater vehicles The tuna was selected as a model for its speed (a blue fin tuna can go up to 74 km/h) and its accelerations It is a question of understanding...
  • 276
  • 144
  • 0

Modelling and classification of motor imagery EEG for BCI

Modelling and classification of motor imagery EEG for BCI
... between motor imagery and executed movement [39, 40, 41] Moreover, motor imagery can even lead to performance improvements for athletes, and previous studies also suggest the effectiveness of motor imagery ... motor imagery, BCI can translate motor imagery of certain actions into commands for possible orthosis to perform predefined tasks, which is illustrated by Figure 1.1 On the one hand, the motor- imagery- based ... perspective of subspace The outcomes of this study may improve the capabilities of BCI in detecting and classifying motor imagery EEG: i) with more complex underlying dynamics of motor imagery being...
  • 186
  • 95
  • 0

Modelling and simulation of faceted boundary structures and dynamics in FCC crystalline materials

Modelling and simulation of faceted boundary structures and dynamics in FCC crystalline materials
... most special type of faceted boundary is the twin boundary Various types of twin boundaries including deformation twins, transformation twins and growth twins with twin sizes ranging from a few ... studies indicate the ultrahigh strength of nanotwinned crystalline metals is related to nanotwin induced interface strengthening The increase in strength with decreasing grain size/twin spacing is ... twinning plane The plane defined by the intersection of K1 and K2 is the shearing plane The two directions η1 and η2 , lying in K1 and K2 , are perpendicular to the line of intersection of K1 and...
  • 183
  • 114
  • 0

Modelling and control of subsea installation

Modelling and control of subsea installation
... Modeling and Control of Subsea Installation How Voon Ee (B.Eng, NATIONAL UNIVERSITY OF SINGAPORE ) A THESIS SUBMITTED FOR THE DEGREE OF DOCTOR OF PHILOSOPHY DEPARTMENT OF ELECTRICAL AND COMPUTER ... writing, project planning and management, manpower recruitment, documentation and hard work in meeting deliverables of two research projects: Modelling and Control of Subsea Installation, funded by ... strategies for the control of subsea installation operations and exible structures in the marine environment and alleviate some of the challenges Splash Zone Transition Control: For the subsea system...
  • 164
  • 65
  • 0

Modelling and simulation of ion implantation induced damage

Modelling and simulation of ion implantation induced damage
... crystal structure Understanding of ion implantation induced damage is crucial as it affects device performance In addition, modeling and simulation of ion implantation induced damage is complicated ... fabrication of transistors, it is essential to understand the impact of a buried oxide interface on defect evolution and dopant diffusion 1.1.2 Modeling and Simulation of Ion Implantation Induced Damage ... Experimental observations of ion- implantation induced damage accumulation In this section, an overview of experimental findings on the dependence of ionimplantation parameters on damage accumulation is presented...
  • 191
  • 58
  • 0

Xem thêm

Từ khóa: modeling simulation and optimization of industrial fixed bed catalytic reactorsdynamic modelling and control of a wheeled mobile robottheory modelling and calibration of passive samplers used in water monitoringanalysis prediction and optimisation of downlink capacityimproving modelling and assessment of clinical processesmodelling the determinants of capital flows and capital flighthydrodynamics of a dual fluidized bed gasifiergermination emergence and early plant biomass production of brassicae oilseed cropsgetting in and out of bedeffect of sa and cd on the amount of biomass total lipophilic extracts and famephotosynthesis of biomass and its conversion related propertiesmodelling and simulation for the recognition of physiological and behavioural traits through humhuman modelling and simulation to support human error risk analysis of partially autonomous driver assistance systemsactivity of microbes and the microbial biomassbiomass vegetation height and percentage of bare soilDiseases of children in the subtropics and tropicsCommercial correspondence practice Thực hành thư tín thương mạiĐề cương chi tiết học phần Máy điện đặc biệt (Đại học sư phạm kĩ thuật TP.HCM)Đề cương chi tiết học phần Hệ thống BMS (Đại học sư phạm kĩ thuật TP.HCM)Đề cương chi tiết học phần quản trị công nghiệp (Đại học sư phạm kĩ thuật TP.HCM)Đề cương chi tiết học phần Thực tập điện (Đại học sư phạm kĩ thuật TP.HCM)TIỂU THUYẾT PHÓNG SỰ VIỆT NAM THẾ KỈ XXLuận văn ứng dụng hóa học trong thực tiếnỨng dụng phần mềm gcadas trong công tác xây dựng bản đồ hiện trạng sử dụng đất và kiểm kê đất đai năm 2015 cho thành phố lạng sơn, tỉnh lạng sơnĐặc trưng nghệ thuật tiểu thuyết của nhà văn Lào Suvănthon BupphanuvôngBỆNH HỌC NÃO KHOA TỪ ĐẠI CƯƠNG TỚI THỰC HÀNH LÂM SÀNGQuản lý công tác xã hội hóa giáo dục tại các trung tâm học tập cộng đồng của huyện kim bảng, tỉnh hà namQuản lý đào tạo, bồi dưỡng giảng viên các trường cao đẳng công lập trên địa bàn thành phố hà nộiQuản lý hoạt động dạy học các trường tiểu học của phòng giáo dục quận hải an thành phố hải phòng trong bối cảnh đổi mớiQuản lý hoạt động giáo dục quốc phòng và an ninh cho sinh viên ở các cơ sở giáo dục đại học theo tiếp cận quản lý chất lượng tổng thểQuản lý văn hóa tổ chức của các đại học ở việt namVai trò của nhà nước trong cung ứng dịch vụ công ở việt nam hiện nayTài liệu ôn đầu vào tiếng anh sau đại học sư phạm 1Giải pháp phát triển du lịch sinh thái phường long phước, quận 9, TP HCM đến năm 2020, định hướng đến năm 2025CÁC NHÂN tố ẢNH HƯỞNG đến sự hài LÒNG về TOUR DU LỊCH TRONG nước của DU KHÁCH ở THÀNH PHỐ hồ CHÍ MINH tại CÔNG TY TNHH MTV DỊCH vụ lữ HÀNH SAIGONTOURIST
Nạp tiền Tải lên
Đăng ký
Đăng nhập