Modeling of chloride penetration onto concrete structures under flexual cyclic load and tidal environment

modeling of chloride penetration onto concrete structures under flexual cyclic load and tidal environment

... MODEL / CHLORIDE PENETRATION / CONCRETE / FLEXURAL CYCLIC LOAD / TIDAL ENVIRONMENT MIEN VAN TRAN: MODELING OF CHLORIDE PENETRATION INTO CONCRETE STRUCTURES UNDER FLEXURAL CYCLIC LOAD AND TIDAL ENVIRONMENT ... period of concrete structures under combination of cyclic loading and tidal environment Do the experimental flexural cyclic loading of concrete structures in the simulated marine environment – tidal ... Prediction of chloride profiles of concretes subjected to cyclic load and year exposure to tidal environment, w/c=0.4 89 Figure 4.14 Prediction of chloride profiles of concretes subjected to cyclic...

Hydraulic modeling of open channel flows over an arbitrary 3-d surface and its applications in amenity hydraulic engineering

... contents of the following published and/ or accepted journal and conference papers: Anh T N and Hosoda T.: Depth-Averaged model of open channel flows over an arbitrary 3D surface and its applications ... predicted the water surface profile and velocity distribution well in simple channels, and the predictions of the model in main channel of compound meandering channel were also in general agreement ... analysis of water surface profile Journal of Hydraulic Engineering, ASCE (accepted on May 12, 2006) Anh T N and Hosoda T.: Oscillation induced by the centrifugal force in open channel flows over...

Báo cáo hóa học: "Research Article Modeling of Electric Disturbance Signals Using Damped Sinusoids via Atomic Decompositions and Its Applications" ppt

... Rodrigues, and P S R Diniz, “Coherent decompositions of power systems signals using damped sinusoids with applications to denoising,” in Proceedings of IEEE International Symposium on Circuits and Systems ... estimate the parameters of damped sinusoids embedded in several signals [39–46] In [21, 47], disturbance signals are modeled using a fundamental, a set of harmonics, and after subtracting these ... recognition [51] and signal modeling [49, 76] using atomic decompositions The decomposition algorithm in Section employs a parameterized dictionary of damped sinusoids in order to obtain an atomic signal...

Báo cáo y học: "Structural and functional characterization of human apolipoprotein E 72-166 peptides in both aqueous and lipid environments" pot

... concentration of DHPC Protein -lipid interactions and Protein-LDLR binding of ApoE- (72-166) Proteins To identify and compare the lipid binding ability of the three apoE- (72-166) peptides, we assessed ... Received: 17 September 2010 Accepted: 10 January 2011 Published: 10 January 2011 References Weisgraber KH, Rall SC Jr, Mahley RW: Human E apoprotein heterogeneity Cysteine-arginine interchanges ... apoE3 and apoE4, and with apoE2-, apoE3-, and apoE4- (72-166) proteins, respectively The VLDL bands were shifted with the binding of apoE proteins Detailed procedures are described in Materials and...

Design of concrete structures arthur h nilson

...

stochastic approach to risk assessment of project finance structures under public private partnerships

... Reproduced with permission of the copyright owner Further reproduction prohibited without permission Reproduced with permission of the copyright owner Further reproduction prohibited ... without permission Reproduced with permission of the copyright owner Further reproduction prohibited without permission Reproduced with permission of the copyright owner Further reproduction prohibited ... without permission Reproduced with permission of the copyright owner Further reproduction prohibited without permission Reproduced with permission of the copyright owner Further reproduction prohibited...

considerations for design of concrete structures subjected to fatigue loading

... microcracking as compared to fracture of concrete under incorporates the influence of range of loading For a zero static loading. 3,4 4Fatigue strength of concrete for a life of ten minimum stress ... guide for design for concrete structures subjected to fatigue loading However, this report does not contain the type of detailed design procedures sometimes found in guides Chapter presents information ... reinforcement in concrete structures However, the trend in concrete structures toward use of ultimate strength design procedures and higher yield strength reinforcement makes fatigue of reinforcing...

control of cracking in concrete structures

... restraint needed for shrinkage-compensating concrete To take full advantage of the expansive potential of shrinkage-compensating concrete in minimizing or preventing shrinkage cracking of exposed concrete ... use of shrinkage-compensating concrete are contained in ACI 223R CHAPTER 4 CONTROL OF CRACKING IN FLEXURAL MEMBERS 4.1—Introduction The control of cracking can be as important as the control of ... found in ACI 209R Cracking due to drying shrinkage can never be eliminated in most structures This chapter covers cracking of hardened concrete due to drying shrinkage, factors influencing shrinkage,...

prediction of creep, shrinkage, and temperature effects in concrete structures

... Z.P., “Theory of Creep, and Shrinkage in Concrete Structures: A Precis of Recent Developments,” by D.E Branson) Prediction of Creep, Shrinkage and Temperature Effects in Concrete Structures, ” ... Report, Prediction of Creep, Shrinkage, and Experimental Studies of Time-Dependent Deflections of Temperature Effects in Concrete Structures, ” Private Non-Composite and Composite Reinforced Concrete ... 209, Effects of Concrete Constituents, Environment, and Stress on the Creep and Shrinkage of Concrete, ” Symposium on Creep, Shrinkage, and Temperature Effects SP-27-1, American Concrete Institute,...

recommendations for design of beam-column connections in monolithic reinforced concrete structures

... for Deformed Bars in Tension 352 Recommendations for Design of Slab-Column Connections in Monolithic Reinforced Concrete Structures ASTM A 706 BEAM-COLUMN CONNECTIONS IN MONOLITHIC CONCRETE STRUCTURES ... γ-values shown in Table assume that extensive inclined cracking would occur in the joint Tests indicate that initial inclined cracking in well-confined interior joints occurs at levels of nominal shear ... Requirements for Interior Beam-Column Connections, ” Proceedings of the International Symposium on Fundamental Theory of Reinforced and Prestressed Concrete, Nanjing Institute of Technology, China, Sept...

control of deflection in concrete structures

... strain in the extreme compression fiber of a concrete element (0.003 in. /in. ) strain at first cracking load strain in prestressed reinforcement at ultimate flexure unit shrinkage strain in concrete ... nonprestressed reinforcement overall thickness of member depth of flange moment of inertia of cracked section transformed to concrete effective moment of inertia for computation of deflection moment of inertia ... evaluating the long-term deflection of a twoway reinforced concrete slab Chapter 5, “Reducing Deflection of Concrete Members,” gives practical and remedial guidelines for improving and controlling...

design and construction of circular prestressed concrete structures with circumferential tendons

... 1.2—Objective The objective of this report is to provide guidance in the design and construction of circular prestressed concrete structures circumferentially prestressed using tendons 1.3—Scope The ... facilitate placement of the concrete without segregation (a) 10 in for cast-in-place concrete walls with internal circumferential tendons, with or without vertical tendons, and with conventional ... precast concrete walls with internal circumferential tendons, and with vertical tendons or mats of nonprestressed vertical reinforcement (d) in for precast concrete walls with internal circumferential...

Xem thêm