0
  1. Trang chủ >
  2. Công Nghệ Thông Tin >
  3. Kỹ thuật lập trình >

Signaling System No 7 Protocol Architecture And Sevices part 28 ppt

Signaling System No.7 Protocol Architecture And Sevices part 28 ppt

Signaling System No.7 Protocol Architecture And Sevices part 28 ppt

... specified by the ITU-T. Table 9-12. ITU-T Specified Subsystem Numbers [60] Bits 8 7 6 5 4 3 2 1 Subsystem 0 0 0 0 0 0 0 0 SSN not known/not used 0 0 0 0 0 0 0 1 SCCP management 0 0 0 0 0 ... designated nodes, generally an STP, although SSP or SCP nodes are normally capable of performing GTT. Even the SP that has been requested by another SP to perform GTT does not have to know the ... MTP to appropriate local subsystem. • Routes messages from local subsystems to other local subsystems. • Routes messages from local subsystems to subsystems in remote nodes by utilizing MTP's...
  • 13
  • 120
  • 0
Signaling System No.7 Protocol Architecture And Sevices part 2 ppt

Signaling System No.7 Protocol Architecture And Sevices part 2 ppt

... Associated Signaling (CAS) techniques and systems. However, for the past two decades, it has been replaced with Common Channel Signaling (CCS) systems. Apart from a rare trace of Signaling System No. ... (SS6) signaling, System No. 7 (SS7) is almost the exclusive CSS system; thus, CCS can almost be taken to refer exclusively to the use of SS7. The remaining sections of this chapter discuss CAS and ... 2, "Standards." Table 1-1. Tones Used to Create DTMF Signals 1209 Hz 1336 Hz 1 477 Hz 1633 Hz6 97 Hz 1 2 3 A 77 0 Hz 4 5 6 B 852 Hz 7 8 9 C 941 Hz * 0 # D Subscriber Signaling...
  • 6
  • 279
  • 0
Signaling System No.7 Protocol Architecture And Sevices part 22 pptx

Signaling System No.7 Protocol Architecture And Sevices part 22 pptx

... with non-SS7 facilities (for example, MF trunks). Interworking with non-SS7 facilities can limit or prohibit the capability of supplementary services or certain call types that require SS7 signaling. ... of 000 and 001 are normal event class, and a value of 010 is resource unavailable. So, a cause value of 1 (unallocated number) is in the normal event class and a cause value of 34 (no circuit ... the message (for example, an IAM, ACM, and so on). • Mandatory Fixed Part Required message parameters that are of fixed length. • Mandatory Variable Part Required message parameters that...
  • 13
  • 259
  • 0
Signaling System No.7 Protocol Architecture And Sevices part 39 ppt

Signaling System No.7 Protocol Architecture And Sevices part 39 ppt

... called party is being alerted. Customized Announcement (10000011)— Used to identify a customized announcement that is not part of the standard announcements. It includes an Announcement Set and ... to another DN in the same office. • Unassigned DN (6)— The DN is valid, but not assigned or not subscribed to a customer. • Multi-Party (7) — A line shared by two or more parties. • Non-Specific ... the parameter. Standard Announcement (10000010)— Indicates one of the standard announcements, which include: • Out of Band (01)— Customer is not subscribed to this zone or band. • Vacant Code...
  • 12
  • 189
  • 0
Signaling System No.7 Protocol Architecture And Sevices part 44 ppt

Signaling System No.7 Protocol Architecture And Sevices part 44 ppt

... Base Station Subsystem Application Part (BSSAP) and Mobile Application Part (MAP)—are applications (subsystems) that utilize the underlying functionality of the SS7 protocols and network. This ... interfaces and SS7/C7 protocols that are used in the NSS and BSS. Figure 12-1 shows a general GSM architecture to illustrate the scope and the entities that comprise the three subsystems. Figure ... incoming calls to be delivered. NOTE Handovers and location tracking involve extensive and complex SS7/C7 signaling. In a cellular network, most signaling relates to the support of roaming...
  • 13
  • 211
  • 0
Signaling System No.7 Protocol Architecture And Sevices part 54 ppt

Signaling System No.7 Protocol Architecture And Sevices part 54 ppt

... automatic allocation of Signaling Terminals and Signaling Data Links. The Registration Request requests that an Interface Identifier be assigned to a Signaling Data Terminal and Signaling Data Link ... sides of the M2PA protocol must be assigned an SS7 point code. Two IPSPs can use M2PA IP links and standard SS7 links simultaneously to send and receive MTP Level 3 messages. Figure 14-21 ... reporting asynchronous status changes to layer management M2PA can be used between a SG and a MGC, between a SG and an IPSP, and between two IPSPs. In any scenario, both sides of the M2PA protocol must...
  • 9
  • 161
  • 0
Signaling System No.7 Protocol Architecture And Sevices part 60 ppt

Signaling System No.7 Protocol Architecture And Sevices part 60 ppt

... [90]. • Q .78 3 [89] covers TUP [64] • Q .78 4.1 [90] covers ISUP [75 78 , 80–81] • Q .78 5 [91] covers ISUP Supplementary Services [69] • Q .78 6 [92] covers SCCP [58–63] • Q .78 7 [93] covers ... ITU-T specifies ISUP in recommendations Q .76 1–Q .76 4 [75 78 , 80]. The British Standards Institute (BSI) specify the UK nationalized version in PNO-ISC #0 07 [41]. If we were to test UK ISUP, we ... exceptions to Q .76 2 (ISUP general functions and signals), no UK-specific signaling messages have been defined; therefore, no new tests are required to check the validation and interoperability...
  • 7
  • 187
  • 0
Signaling System No.7 Protocol Architecture And Sevices part 66 pptx

Signaling System No.7 Protocol Architecture And Sevices part 66 pptx

... circuit and to transmit number and other information related to the routing and the handling of a call. RSC 0 0 0 1 0 0 1 0 Reset Circuit Sent when an exchange does not know the state of a particular ... (I) (NS 67) 0 0 1 1 0 1 0 1 User Part Available Sent in either direction as a response to a user part& apos;s test message to indicate that the user part is available. UPT (I) (NS 67) 0 0 ... user-to-user signaling, independent of call-control messages. KEY: Note that the absence of a symbol beside a message indicates that the message exists in ITU-T ISUP [75 78 ], ETSI ISUP [18] and in...
  • 7
  • 301
  • 0
Signaling System No.7 Protocol Architecture And Sevices part 3 pps

Signaling System No.7 Protocol Architecture And Sevices part 3 pps

... therefore, signaling is sent above the 3400 Hz (and below 4000 Hz). This is known as out-of-band signaling and is used in R2 for supervisory signaling. Unlike with in-band signaling, no contention ... implemented using the following related systems: • Bell Systems MF, R2, R1, and C5. • Single-frequency (SF) in-band and out-of-band signaling • Robbed bit signaling The following sections discuss ... frequency bandwidth, only signaling or user traffic can be present at any one time. Therefore, in-band signaling is restricted to setting up and clearing calls down only because signaling is not possible...
  • 7
  • 305
  • 0
Signaling System No.7 Protocol Architecture And Sevices part 4 potx

Signaling System No.7 Protocol Architecture And Sevices part 4 potx

... digital CAS signaling. The only CCS systems that have been implemented to date are Signaling Systems No. 6 and No. 7 (SS6 and SS7). The ITU for the international network originally standardized ... telecommunications standards and for Internet standards. These two worlds are now intersecting, creating the need for additional standards to address new architectures, protocols, and features. Test ... wireless, and fixed-line standards are all being addressed by the SS7/C7 standards bodies is a sign of the central role that SS7/C7 plays in the convergence of today's voice and data networks....
  • 6
  • 340
  • 0

Xem thêm

Từ khóa: how to install dual operating system windows 7 and xphow to install dual operating system windows 7 and 8how to install dual operating system windows 7 and ubuntuexplain unix operating system architecture and its propertiesthe hadoop distributed file system architecture and design pdfhow to install dual operating system windows 7 and windows 8Báo cáo thực tập tại nhà thuốc tại Thành phố Hồ Chí Minh năm 2018Nghiên cứu sự biến đổi một số cytokin ở bệnh nhân xơ cứng bì hệ thốngBáo cáo quy trình mua hàng CT CP Công Nghệ NPVBiện pháp quản lý hoạt động dạy hát xoan trong trường trung học cơ sở huyện lâm thao, phú thọGiáo án Sinh học 11 bài 13: Thực hành phát hiện diệp lục và carôtenôitGiáo án Sinh học 11 bài 13: Thực hành phát hiện diệp lục và carôtenôitGiáo án Sinh học 11 bài 13: Thực hành phát hiện diệp lục và carôtenôitĐỒ ÁN NGHIÊN CỨU CÔNG NGHỆ KẾT NỐI VÔ TUYẾN CỰ LY XA, CÔNG SUẤT THẤP LPWANPhối hợp giữa phòng văn hóa và thông tin với phòng giáo dục và đào tạo trong việc tuyên truyền, giáo dục, vận động xây dựng nông thôn mới huyện thanh thủy, tỉnh phú thọPhát triển mạng lưới kinh doanh nước sạch tại công ty TNHH một thành viên kinh doanh nước sạch quảng ninhNghiên cứu tổng hợp các oxit hỗn hợp kích thƣớc nanomet ce 0 75 zr0 25o2 , ce 0 5 zr0 5o2 và khảo sát hoạt tính quang xúc tác của chúngĐịnh tội danh từ thực tiễn huyện Cần Giuộc, tỉnh Long An (Luận văn thạc sĩ)Tìm hiểu công cụ đánh giá hệ thống đảm bảo an toàn hệ thống thông tinThiết kế và chế tạo mô hình biến tần (inverter) cho máy điều hòa không khíKiểm sát việc giải quyết tố giác, tin báo về tội phạm và kiến nghị khởi tố theo pháp luật tố tụng hình sự Việt Nam từ thực tiễn tỉnh Bình Định (Luận văn thạc sĩ)Quản lý nợ xấu tại Agribank chi nhánh huyện Phù Yên, tỉnh Sơn La (Luận văn thạc sĩ)Nguyên tắc phân hóa trách nhiệm hình sự đối với người dưới 18 tuổi phạm tội trong pháp luật hình sự Việt Nam (Luận văn thạc sĩ)Giáo án Sinh học 11 bài 14: Thực hành phát hiện hô hấp ở thực vậtTrách nhiệm của người sử dụng lao động đối với lao động nữ theo pháp luật lao động Việt Nam từ thực tiễn các khu công nghiệp tại thành phố Hồ Chí Minh (Luận văn thạc sĩ)Đổi mới quản lý tài chính trong hoạt động khoa học xã hội trường hợp viện hàn lâm khoa học xã hội việt nam